Ana içeriğe geç

Giriş

This guide will show step by step instructions on how to replace the Samsung Gear S speaker.

Parçalar

Hiçbir parça belirtilmedi.

  1. Remove the wrist strap by peeling back the rubber starting from one corner of the watch face. Continue peeling the rubber away from the watch face until the strap is completely off. Remove the wrist strap by peeling back the rubber starting from one corner of the watch face. Continue peeling the rubber away from the watch face until the strap is completely off. Remove the wrist strap by peeling back the rubber starting from one corner of the watch face. Continue peeling the rubber away from the watch face until the strap is completely off.
    • Remove the wrist strap by peeling back the rubber starting from one corner of the watch face. Continue peeling the rubber away from the watch face until the strap is completely off.

  2. Starting from an edge, wedge a metal spudger in between the screen and the chrome trim ring and pry, lifting the screen outwards. Some force is needed due to adhesive seal.
    • Starting from an edge, wedge a metal spudger in between the screen and the chrome trim ring and pry, lifting the screen outwards.

    • Some force is needed due to adhesive seal.

  3. Use a plastic opening tool to  gently pry upwards on the plastic motherboard assembly.
    • Use a plastic opening tool to gently pry upwards on the plastic motherboard assembly.

  4. Locate the ribbon assembly attaching the display to the motherboard.
    • Locate the ribbon assembly attaching the display to the motherboard.

  5. Use a plastic opening tool to detach the glass screen/ LED Display ribbon connector from the motherboard.
    • Use a plastic opening tool to detach the glass screen/ LED Display ribbon connector from the motherboard.

  6. Now the watch should be in three separate pieces.
    • Now the watch should be in three separate pieces.

  7. Locate the speaker in the upper left corner of the housing.
    • Locate the speaker in the upper left corner of the housing.

    • Locate the speaker ribbon connector directly below the speaker.

  8. Use the plastic opening tool to gently pry upwards on the speaker's ribbon connector.
    • Use the plastic opening tool to gently pry upwards on the speaker's ribbon connector.

  9. Use the  spudger to gently pry upwards on the speaker housing.
    • Use the spudger to gently pry upwards on the speaker housing.

    • Note: The speaker housing is attached with adhesive, therefore, some force is required.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

Luis Franco

Üyelik tarihi: 03-09-2015

1.040 İtibar

4 adet Kılavuz yazıldı

Takım

USF Tampa, Team 12-1, Blackwell Fall 2015 USF Tampa, Team 12-1, Blackwell Fall 2015 üyesi

USFT-BLACKWELL-F15S12G1

4 Üyeler

5 adet Kılavuz yazıldı

2 Yorum

Do you have a place where we can buy the speaker part?

christopher borget - Yanıt

Ya. Looking for speaker part myself... Where we find it at?

Tony Tone - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 1

Son 30 Gün: 13

Her zaman: 2,807