Eşyalarını Tamir Et Topluluk Mağaza

Samsung Impression Camera Replacement

Giriş

How to remove & replace the phone's back camera.

Neye ihtiyacın var

  1. Samsung Impression Camera Replacement, Battery: adım 1, 1 resimden 1.

    • Orient the phone with the screen facing down.

    • Using your thumb, slide the back panel away from the camera to expose the battery.

    Düzenle

  2. Samsung Impression Camera Replacement: adım 2, 2 resimden 1. Samsung Impression Camera Replacement: adım 2, 2 resimden 2.

    • Insert the tip of the spudger on the left side of the battery, opposite the direction of the white arrow.

    • Pry the battery free. It will pivot in the direction of the white arrow.

    Düzenle

  3. Samsung Impression Camera Replacement, Back Cover: adım 3, 1 resimden 1.

    • Remove the six 3.5 mm screws using a Phillips #000 screwdriver. Make sure to unscrew in a counterclockwise direction.

    Düzenle

  5. Samsung Impression Camera Replacement: adım 4, 1 resimden 1.

    • Remove the back cover by gently prying around the top and bottom edges with the spudger.

    • It may help to slide the touchscreen upwards when removing the back panel.

    • The side buttons will become loose and will fall out, so put these in a safe place.

    Düzenle

  6. Samsung Impression Camera Replacement, Circuit Board: adım 5, 1 resimden 1.

    • To free the circuit board, remove the black wire that is holding it down.

    • You can remove the wire by gently prying up the gold terminator that is attached to the green circuit board. A gentle tug is all it should take.

    Düzenle

  7. Samsung Impression Camera Replacement: adım 6, 2 resimden 1. Samsung Impression Camera Replacement: adım 6, 2 resimden 2.

    • The circuit board will still be held on by a blue and black ribbon. Remove the entire circuit board by gently tugging the ribbon upwards.

    Düzenle

  8. Samsung Impression Camera Replacement, Camera: adım 7, 2 resimden 1. Samsung Impression Camera Replacement, Camera: adım 7, 2 resimden 2.

    • Turn the circuit board over.

    • The bottom of the camera will have a gold ribbon coming out of it which attaches to the circuit board.

    • Pull upwards on the blue rectangle where the gold ribbon ends. This will remove the camera from the circuit board.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

4 tane daha katılımcı ile

Saul Villatoro

Üyelik tarihi: 04/25/11

255 İtibar

7 adet Kılavuz yazıldı

Rozetler: 8

+5 tane daha rozet

Ekip

Cal Poly, Team 8-10, Regan Spring 2011 Cal Poly, Team 8-10, Regan Spring 2011 üyesi

CPSU-REGAN-S11S8G10

4 Üyeler

22 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 1,566