Apply pressure to the back cover and slide it forward towards the camera.
  • Apply pressure to the back cover and slide it forward towards the camera.

  • Lift the back cover off the phone.

Yorum Ekle

Holding the phone firmly, use the notches to grip and lift up the battery.
  • Holding the phone firmly, use the notches to grip and lift up the battery.

Yorum Ekle

  • Remove the four 4.45mm screws at the corners of the phone.

Yorum Ekle

  • Use the plastic opening tool to unhinge the locks around the edges of the phone.

  • Do not worry about the inner components of the phone; they are not connected to this case.

Yorum Ekle

  • Lift the casing off of the phone.

Yorum Ekle

  • With the screws removed, locate the antenna.

Yorum Ekle

  • Using a Phillips head screwdriver, remove the 4.50mm screw holding the antenna in place.

Yorum Ekle

  • Using the plastic opener tool, squeeze gently on the antenna cable connector and lift to remove the connector from its position.

Yorum Ekle

  • Gently lift up on the antenna and remove it from the back of the device.

Yorum Ekle

  • Remove the two 3.50mm screws connecting the motherboard to the case.

Yorum Ekle

  • Use the plastic opener tool to detach the three ribbons on the motherboard.

Yorum Ekle

  • Lift out the top right ribbon from its slot on the motherboard.

Yorum Ekle

  • Use the plastic opener tool to unhinge the the locks on the side of the motherboard connecting it to the front casing.

Yorum Ekle

  • Lift the motherboard away from the front casing.

Yorum Ekle

  • After removing lifting up on the motherboard, the front casing and center frame should be separated as shown.

Yorum Ekle

  • Using the plastic opener tool, gently pry away the side strip control buttons from the metal center frame.

  • There are three strips total: one on the right, left, and top of the phone.

Yorum Ekle

  • Using the plastic opener tool, pry the speaker connector away from the back of the motherboard.

Yorum Ekle

  • Using the plastic opener tool, remove the speaker from its setting.

  • Pry where the wire enters the speaker.

  • The speaker has adhesive on the bottom, thus removing it will require a bit of wiggling.

Yorum Ekle

  • Gently lift the motherboard from the center frame.

Yorum Ekle

  • Once the motherboard is removed from the frame, use the pry tool to remove the camera.

  • Insert the pry bar between the camera and the frame then lift up.

  • The camera is held in by adhesive so it will require some force to remove.

  • You have now successfully removed the camera from your Samsung Instinct.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Patrick

Üyelik tarihi: 11-10-2011

60 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 3-13, Regan Fall 2011 Cal Poly, Team 3-13, Regan Fall 2011 üyesi

CPSU-REGAN-F11S3G13

4 Üyeler

16 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 729