Be sure to unplug the vacuum before disassembling it to prevent electric shock.
  • Be sure to unplug the vacuum before disassembling it to prevent electric shock.

  • Lay vacuum on side.

  • Using a Phillips screwdriver, unscrew the screw behind the front wheels, on the edge of the underside of the vacuum cleaner.

Yorum Ekle

Stand the vacuum upright and identify the dial on the front of the vacuum.
  • Stand the vacuum upright and identify the dial on the front of the vacuum.

  • Unscrew the screw using a Torx 20 screwdriver

  • Pull the dial out.

Yorum Ekle

  • Lift the cover off of the vacuum.

Yorum Ekle

  • Identify the two gray metal plates at the front of the vacuum.

  • Using the T20 Torx screwdriver, remove the four screws on the smaller gray plate holding the larger gray metal plates.

Yorum Ekle

  • Remove the small metal plate with the black bolt in the center.

  • Repeat on opposite side near the other wheel

Yorum Ekle

  • Remove the larger gray metal plate.

  • Repeat on opposite side near other wheel.

Yorum Ekle

  • Remove the front wheels by lifting the silver bar that attaches the two wheels.

  • Detach the spring attaching the wheels to the vacuum.

Yorum Ekle

  • Remove a wheel from the wheel's axel by pulling off the wheel.

  • Slide spring off.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Caycie Pascual

Üyelik tarihi: 26-09-2012

1 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 16-58, Forte Fall 2012 Cal Poly, Team 16-58, Forte Fall 2012 üyesi

CPSU-FORTE-F12S16G58

5 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 682