Parçalar

Hiçbir parçaya gerek yok.

Using a Phillips head screwdriver remove  six screws from the bottom of the console. The six screws are marked.
  • Using a Phillips head screwdriver remove six screws from the bottom of the console.

    • The six screws are marked.

Yorum Ekle

Remove the two screws that attach the Genesis' connector to the rest of the console.
  • Remove the two screws that attach the Genesis' connector to the rest of the console.

    • The two screws are marked in the diagram.

Yorum Ekle

Slide the lock tab to the left to separate the halves of the console.
  • Slide the lock tab to the left to separate the halves of the console.

Yorum Ekle

Lift from the left side to remove the top of the case.
  • Lift from the left side to remove the top of the case.

Yorum Ekle

Using the spudger, pry the cover off of the Genesis attachment.
  • Using the spudger, pry the cover off of the Genesis attachment.

Yorum Ekle

Lift the top of the case to remove the cover.
  • Lift the top of the case to remove the cover.

Yorum Ekle

Remove the faceplate by pulling it up, then out.
  • Remove the faceplate by pulling it up, then out.

Yorum Ekle

Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate. The three screws are shown on the diagram.
  • Remove metal plate by unscrewing the three screws with the Phillips head screwdriver and then lifting the plate.

    • The three screws are shown on the diagram.

Yorum Ekle

Remove the two screws from the plastic bar. The two screws are shown pictured.
  • Remove the two screws from the plastic bar.

    • The two screws are shown pictured.

Yorum Ekle

To remove the CD tray Remove the four screws with the Phillips head screwdriver.
  • To remove the CD tray

    • Remove the four screws with the Phillips head screwdriver.

Yorum Ekle

Carefully unplug the wire connected to optical reader.
  • Carefully unplug the wire connected to optical reader.

Yorum Ekle

Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver. The four screws are highlighted on the diagram.
  • Remove the four screws on the underside of the CD tray with a small Phillips head screwdriver.

    • The four screws are highlighted on the diagram.

  • The four springs below the circuit board are attached to the screws, so be careful not to lose them when you remove the screws.

Yorum Ekle

Carefully remove the CD tray from circuit board.
  • Carefully remove the CD tray from circuit board.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

sskyllin

Üyelik tarihi: 18-10-2010

21 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 5-14, Maness Fall 2010 Cal Poly, Team 5-14, Maness Fall 2010 üyesi

CPSU-MANESS-F10S5G14

5 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 3

Son 7 Gün: 9

Son 30 Gün: 35

Tüm Zamanlar: 6,608