Giriş

We all know that the Sega Genesis brought to us many hours of fun, but, as we get older, the reset button gets older too.

Today, let's lend a hand to our nice friend and replace its reset button!

Parçalar

Hiçbir parçaya gerek yok.

  1. Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
    • Remove the six screws from the underside of the console with a Phillips #1 screwdriver.

  2. Flip the Sega Genesis upright.
    • Flip the Sega Genesis upright.

  3. Gently lift the top casing.
    • Gently lift the top casing.

    • Note: the case will be connected to the main board by LED wires.

  4. Bend out the LED leads into vertical positions.
    • Bend out the LED leads into vertical positions.

  5. Pro Tech Toolkit içeren veya $100tüm siparişlerde ücretsiz kargo!

    Mağazamıza Göz Atın
  6. Slide the LED wire apparatus off the lead pins.
    • Slide the LED wire apparatus off the lead pins.

    • Note: observe which color wire corresponds with which length of pin.

  7. Separate the main board from the outer case.
    • Separate the main board from the outer case.

  8. Using Philips screwdriver, remove 11 screws securing silver casing.
    • Using Philips screwdriver, remove 11 screws securing silver casing.

  9. Remove silver case.
    • Remove silver case.

  10. Locate reset button on motherboard
    • Locate reset button on motherboard

  11. Place three pieces of 1cm x 1cm masking tape over reset button.
    • Place three pieces of 1cm x 1cm masking tape over reset button.

Sonuç

To reassemble your device, follow these instructions in reverse order. And the most important, be happy!

Bir başkası bu kılavuzu tamamladı.

calvin

Üyelik tarihi: 05-10-2010

195 İtibar

1 Kılavuz yazıldı

Takım

Cal Poly, Team 3-29, Regan Fall 2010 Cal Poly, Team 3-29, Regan Fall 2010 üyesi

CPSU-REGAN-F10S3G29

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 13

Son 30 Gün: 66

Her zaman: 11,853