Giriş

A ladder stitch, or closure stitch, is a sewing technique that allows you to close a tear without leaving the stitching visible.

The trick is to make the stitches as small and as even as possible. This technique works for repairing almost any type of tear.

Parçalar

Thread your needle and tie a knot in the end. We're using contrasting thread for visibility, but when it comes time for your repair, you'll want to use matching thread. Drive the needle from the back of the material, just before where the tear starts.
  • Thread your needle and tie a knot in the end.

    • We're using contrasting thread for visibility, but when it comes time for your repair, you'll want to use matching thread.

  • Drive the needle from the back of the material, just before where the tear starts.

  • Pull the thread taut.

Yorum Ekle

Take a small stitch, going in and out of the material, on one side of the tear only. Pull the thread taut.
  • Take a small stitch, going in and out of the material, on one side of the tear only.

  • Pull the thread taut.

Yorum Ekle

Take a small stitch, going in and out of the material, on the other side of the tear, directly opposite of the stitch you just took. Pull the thread taut. This should cinch the material together.
  • Take a small stitch, going in and out of the material, on the other side of the tear, directly opposite of the stitch you just took.

  • Pull the thread taut. This should cinch the material together.

  • If your material bunches, try taking smaller stitches, while ensuring that you line up the stitches on either side of the material.

Yorum Ekle

Continue stitching, switching from side to side as described in step 2 and 3 of this guide, pulling the thread taut after each stitch. Stitch until you come to the end of the tear.
  • Continue stitching, switching from side to side as described in step 2 and 3 of this guide, pulling the thread taut after each stitch.

  • Stitch until you come to the end of the tear.

Yorum Ekle

One the last stitch, drive the needle through both sides of the fabric, taking as small of a stitch as possible. Slowly pull the thread. As you pull, a loop will form. Draw the needle through this loop, and pull the thread taut. Repeat this step, taking a tiny stitch, drawing the needle through the loop, and pulling taut.
  • One the last stitch, drive the needle through both sides of the fabric, taking as small of a stitch as possible.

  • Slowly pull the thread. As you pull, a loop will form. Draw the needle through this loop, and pull the thread taut.

  • Repeat this step, taking a tiny stitch, drawing the needle through the loop, and pulling taut.

  • Ensure that the stitches are tight, and cut any excess threads.

Instead of cutting the excess thread, I leave enough length at the end to “bury” the long threads inside the repair, where they will not show and are less likely to loosen up.

Kathleen Slamka - Yanıt

Bitiş Çizgisi

2 başka kişi bu kılavuzu tamamladı.

Brittany McCrigler

Üyelik tarihi: 05-03-2012

78.135 İtibar

431 adet Kılavuz yazıldı

Takım

iFixit iFixit üyesi

Community

115 Üyeler

5.777 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 15

Son 30 Gün: 58

Her zaman: 4,031