Giriş

Wire cutting and soldering may be required for more info on soldering visit the iFixit soldering guide.

  1. Squeeze Dust Cup release buttons on either side of the component. Pull up to release Dust Cup.
    • Squeeze Dust Cup release buttons on either side of the component.

    • Pull up to release Dust Cup.

  2. Remove the pre-motor filter with your hands. Remove the pre-motor filter with your hands.
    • Remove the pre-motor filter with your hands.

  3. Pro Tech Toolkit içeren veya $100,00tüm siparişlerde ücretsiz kargo!

    Mağazamıza Göz Atın
  4. Remove the post-motor filter.
    • Remove the post-motor filter.

  5. Remove the two 15 mm screws by twisting counterclockwise with the T10 Torx screwdriver.
    • Remove the two 15 mm screws by twisting counterclockwise with the T10 Torx screwdriver.

  6. Remove the two 12 mm screws by twisting counterclockwise with the T15 Torx screwdriver. To fully remove the power cord, cut the wires using a wire cutter.
    • Remove the two 12 mm screws by twisting counterclockwise with the T15 Torx screwdriver.

    • To fully remove the power cord, cut the wires using a wire cutter.

    • For reassembly, use the soldering guide in the Introduction.

Sonuç

To reassemble your device, follow these instructions in reverse order.

caoimhe

Üyelik tarihi: 08-10-2018

562 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team S17-G5, White Fall 2018 Cal Poly, Team S17-G5, White Fall 2018 üyesi

CPSU-WHITE-F18S17G5

4 Üyeler

11 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 3

Son 30 Gün: 14

Her zaman: 52