Ana içeriğe geç

Shark Navigator Motherboard Replacement

Neye ihtiyacın var

  1. Shark Navigator Motherboard Replacement, Roller Brush Compartment: adım 1, 1 resimden 1.
    • Pop out the two small wheels located on the front end of the bottom of the roller brush compartment.

  2. Shark Navigator Motherboard Replacement: adım 2, 2 resimden 1. Shark Navigator Motherboard Replacement: adım 2, 2 resimden 2.
    • Remove the 10 Phillips screws located on the bottom of the roller brush compartment. (Two of these screws are located under the wheels from the previous step.)

    • The screws have varying lengths, so keep track of where each one goes for reassembly.

  3. Shark Navigator Motherboard Replacement: adım 3, 1 resimden 1.
    • Remove the white plastic cover to expose the roller compartment underneath.

  4. Shark Navigator Motherboard Replacement, Motherboard: adım 4, 1 resimden 1.
    • There is one screw at the edge of the circuit board. Unscrew the circuit board before attempting to take it out.

  5. Shark Navigator Motherboard Replacement: adım 5, 1 resimden 1.
    • Take out the circuit board and replace with a new one. It may be better to allow a professional to re-wire the circuit board to the vacuum.

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 farklı kişi bu kılavuzu tamamladı.

Mara

Üyelik tarihi: 03/27/15

469 İtibar

2 adet Kılavuz yazıldı

Ekip

UMass Dartmouth, Team 5-4, Kish Spring 2015 UMass Dartmouth, Team 5-4, Kish Spring 2015 üyesi

UMASSD-KISH-S15S5G4

4 Üyeler

16 adet Kılavuz yazıldı

8 Yorum

Hi ..well done with the instructions.However I do have a Shark rotator vacuum NV501 .Unfortunately the motor on the brush is not working ,so I assume the motor is burnt.My request where could I find a replacement of the motor.I have searched a lot sites online but could not find a place to rebuild nor stock the same motor.Any help would be appreciated.Thank you.....To forward any information please do so on my email jacob.brown at hotmail.com thank you....

jacob - Yanıt

I couldn't figure out how to remove the bottom plate, your guide helped by informing me the last two screws are located under the little wheels. Thank you!

dylananon - Yanıt

When I had mine apart, two black rectangle magnet fell out, I can't figure out where the came from.

mardit - Yanıt

I had the same problem with the magnets - where do they go>

bjolivares1055 -

Also having problem locating both mother board and brush roller motor. Where can i purchase them?

Liz - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 5

Son 30 gün: 22

Her zaman: 7,666