Ana içeriğe geç

Solio CLASSIC2 Removing the Circuit Board

Neye ihtiyacın var

  1. Solio CLASSIC2 Removing the Circuit Board, Disconnecting the Battery: adım 1, 1 resimden 1.
    • Turn off the device by pressing on the clear power button behind the device.

    • To make sure that it is off, make sure the button is not flashing green.

  2. Solio CLASSIC2 Removing the Circuit Board: adım 2, 1 resimden 1.
    • Using the Phillips #1 screwdriver, remove the 2mm screw located on the bottom of the device, near the hinge.

  3. Solio CLASSIC2 Removing the Circuit Board: adım 3, 3 resimden 1. Solio CLASSIC2 Removing the Circuit Board: adım 3, 3 resimden 2. Solio CLASSIC2 Removing the Circuit Board: adım 3, 3 resimden 3.
    • Using the plastic opening tools, gently pry open the side of the large panel.

    • Keeping the tool in, slowly slide the tool along the side of the panel.

  4. Solio CLASSIC2 Removing the Circuit Board: adım 4, 2 resimden 1. Solio CLASSIC2 Removing the Circuit Board: adım 4, 2 resimden 2.
    • Rotate the device 180 degrees.

    • Make sure the opening on other side of the device does not snap closed.

    • Gently slide the plastic opening tool along the side of the panel.

  5. Solio CLASSIC2 Removing the Circuit Board: adım 5, 2 resimden 1. Solio CLASSIC2 Removing the Circuit Board: adım 5, 2 resimden 2.
    • Do not fully pull apart the back panel from the device. Doing so can rip the two red and blue wires attached to the panel.

    • Using both hands, slowly pull apart the back panel from the rest of the device.

    • Gently flip the back panel open so the circuit board faces up and the two panels are side by side.

  6. Solio CLASSIC2 Removing the Circuit Board: adım 6, 2 resimden 1. Solio CLASSIC2 Removing the Circuit Board: adım 6, 2 resimden 2.
    • Softly pinch the red and blue wires close to the white connector.

    • To pull the wires out, wiggle them back and forth until the connector is fully out.

  7. Solio CLASSIC2 Removing the Circuit Board, Circuit Board: adım 7, 1 resimden 1.
    • Unscrew the three 2mm screws holding the circuit board down using a Phillips #1 screwdriver.

  8. Solio CLASSIC2 Removing the Circuit Board: adım 8, 1 resimden 1.
    • Make sure the white USB port cover on the side of the device is pulled out or you won't be able to lift the circuit board.

    • Gently lift the circuit board out of the device using tweezers.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Eric Padilla

Üyelik tarihi: 10/21/13

201 İtibar

2 adet Kılavuz yazıldı

Ekip

Cal Poly, Team 4-28, Amido Fall 2013 Cal Poly, Team 4-28, Amido Fall 2013 üyesi

CPSU-AMIDO-F13S4G28

4 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 221