Giriş

This guide will detail the steps necessary to remove the back cover of the Sony Bloggie 3D Player.

Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.
  • Remove the two 2.5mm Phillips #00 screws using the Philips #00 screwdriver.

Yorum Ekle

Use a plastic opening tool to pry the cover open. After the the cover is partly open as shown, remove the cover with your hands.
  • Use a plastic opening tool to pry the cover open.

  • After the the cover is partly open as shown, remove the cover with your hands.

Yorum Ekle

Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board. Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.
  • Using your hand, or a pair of tweezers, remove the ZIF connector by gently pulling it out of the dock on the circuit board.

Yorum Ekle

Use a plastic opening tool to loosen the back cover off the device. Once the back cover is loose, remove it gently by hand.
  • Use a plastic opening tool to loosen the back cover off the device.

  • Once the back cover is loose, remove it gently by hand.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Timothy Tran

Üyelik tarihi: 30-01-2013

1 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 7-12, Maness Winter 2013 Cal Poly, Team 7-12, Maness Winter 2013 üyesi

CPSU-MANESS-W13S7G12

5 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 1

Son 30 Gün: 5

Her zaman: 268