Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Giriş

This guide will show how to remove the back panel to be able to work inside of the device.

Before any repair work can be done one must remove the device for the vehicle. To do so follow this link to see a general vehicle removal of a stereo system.

Parçalar

Hiçbir parça belirtilmedi.

  1. Locate the clip on the wiring harness.
    • Locate the clip on the wiring harness.

  2. Press down on the clip like you would an Ethernet cable. Rock harness side to side, pulling gently towards you until harness detaches.
    • Press down on the clip like you would an Ethernet cable.

    • Rock harness side to side, pulling gently towards you until harness detaches.

  3. Locate back panel.
    • Locate back panel.

  4. Remove four 11.5mm Phillips #00 (silver) screws from back panel. Remove four 11.5mm Phillips #00 (silver) screws from back panel. Remove four 11.5mm Phillips #00 (silver) screws from back panel.
    • Remove four 11.5mm Phillips #00 (silver) screws from back panel.

  5. Remove four 9.5mm Phillips #00 (black) screws from back panel.
    • Remove four 9.5mm Phillips #00 (black) screws from back panel.

    • Remove two 7.5mm Phillips #00 (black) screws from back panel.

  6. Remove back panel.
    • Remove back panel.

    • On the back panel there will be thermal (white) paste. Do not touch.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Odelkys Marquez

Üyelik tarihi: 22-09-2014

1.022 İtibar

7 adet Kılavuz yazıldı

Takım

USF Tampa, Team 10-2, Brown Fall 2014 USF Tampa, Team 10-2, Brown Fall 2014 üyesi

USFT-BROWN-F14S10G2

3 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 gün: 3

Son 30 gün: 6

Her zaman: 678