Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Mağaza

Giriş

This will be the initial step for getting into your device for repair.

Before any repair work can be done, one must remove the device from the vehicle. To do so follow this link to see a vehicle general removal of a stereo system.

  1. Locate face-plate eject button.
    • Locate face-plate eject button.

  2. Press the eject button. Remove the face-plate.
    • Press the eject button.

    • Remove the face-plate.

  3. Remove two 4.9mm Phillips #00screws on the front of the device. Remove two 7.5mm Phillips #00screws on the front of the device. When the screws are removed, the eject lever may fall into the device. Make sure the device is held horizontal and level.
    • Remove two 4.9mm Phillips #00screws on the front of the device.

    • Remove two 7.5mm Phillips #00screws on the front of the device.

    • When the screws are removed, the eject lever may fall into the device. Make sure the device is held horizontal and level.

  4. Rotate device 90 degrees to either side. Use the plastic opening tool to pry open the top and bottom tab respectively.
    • Rotate device 90 degrees to either side.

    • Use the plastic opening tool to pry open the top and bottom tab respectively.

    • Repeat on opposite side.

  5. Remove front panel.
    • Remove front panel.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Odelkys Marquez

Üyelik tarihi: 22-09-2014

1.022 İtibar

7 adet Kılavuz yazıldı

Takım

USF Tampa, Team 10-2, Brown Fall 2014 USF Tampa, Team 10-2, Brown Fall 2014 üyesi

USFT-BROWN-F14S10G2

3 Üyeler

7 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 2

Son 30 gün: 7

Her zaman: 2,067