Parçalar

Hiçbir parçaya gerek yok.

Remove two screws from the thumb dial panel on the back of the device
  • Remove two screws from the thumb dial panel on the back of the device

Yorum Ekle

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Yorum Ekle

Romove 1 screw from thumb dial panel on the righ side of the device.
  • Romove 1 screw from thumb dial panel on the righ side of the device.

Yorum Ekle

Remove screw from lower right side of the device.
  • Remove screw from lower right side of the device.

Yorum Ekle

Remove 1 screw from the lower left side of the device.
  • Remove 1 screw from the lower left side of the device.

Yorum Ekle

Mac RAM Kitleri
Mac'inizi hızlandırın. Hafızasını en yükseğe çıkar.
Mac RAM Kitleri
Mac'inize daha fazla bellek alın.
Romove 2 screws from the bottom of the device.
  • Romove 2 screws from the bottom of the device.

Yorum Ekle

Remove the thumb dial panel by sliding it away from the device.  (note: you can do this step earlier after you remove all screws from thumb drive panel)
  • Remove the thumb dial panel by sliding it away from the device. (note: you can do this step earlier after you remove all screws from thumb drive panel)

Yorum Ekle

Remove the back panel exposing the inside of the device.
  • Remove the back panel exposing the inside of the device.

Yorum Ekle

Remove 1 screw located on board below battery.
  • Remove 1 screw located on board below battery.

Yorum Ekle

Unplug male battery plug on the battery wire from the female battery plug on the board.
  • Unplug male battery plug on the battery wire from the female battery plug on the board.

Yorum Ekle

remove the battery from the device by sliding it out of the side of the device
  • remove the battery from the device by sliding it out of the side of the device

Yorum Ekle

slide new battery under the board from the side of the device.
  • slide new battery under the board from the side of the device.

Yorum Ekle

Plug battery back into board.
  • Plug battery back into board.

Yorum Ekle

Place screw back into board.
  • Place screw back into board.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Rob

Üyelik tarihi: 04-10-2011

1 İtibar

2 adet Kılavuz yazıldı

Takım

UW Stout, Team 5-6, Zhou Fall 2011 UW Stout, Team 5-6, Zhou Fall 2011 üyesi

UWSTOUT-ZHOU-F11S5G6

4 Üyeler

2 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 1

Son 30 Gün: 3

Her zaman: 1,440