Parçalar

Hiçbir parçaya gerek yok.

Remove 2 screws from thumb dial panel on the back of the device.
  • Remove 2 screws from thumb dial panel on the back of the device.

Yorum Ekle

Remove 1 screw from upper right corner on the back of the device.
  • Remove 1 screw from upper right corner on the back of the device.

Yorum Ekle

  • Remove 1 screw from thumb dial panel on the right side of the device.

Yorum Ekle

  • Remove screw from lower right side of the device.

Yorum Ekle

  • Remove 1 screw from the lower left side of the device.

Yorum Ekle

  • Remove 2 screws from the bottom of the device.

Yorum Ekle

  • Remove the thumb dial panel by sliding it away from the device.

Yorum Ekle

  • Remove the back panel exposing the inside of the device.

Yorum Ekle

  • Locate thumb dial on top right side of the board.

Yorum Ekle

  • Follow ribbon wire to locate where it plugs into the board. The plug is a flat black square.

Yorum Ekle

  • Pull plug straight up to remove from board.

Yorum Ekle

  • Place plug back on board and push down on center to secure to board.

Yorum Ekle

  • Make sure new thumb dial is sitting flat and the screw holes line up with holes in the board.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Rob

Üyelik tarihi: 04-10-2011

1 İtibar

2 adet Kılavuz yazıldı

Takım

UW Stout, Team 5-6, Zhou Fall 2011 UW Stout, Team 5-6, Zhou Fall 2011 üyesi

UWSTOUT-ZHOU-F11S5G6

4 Üyeler

2 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 873