Giriş

The flash bulb is the component of the camera responsible for illuminating the surroundings of the images. Replacing the flash bulb will require the removal of battery and black plastic housing that holds the CCD chip.

Locate the cover on the bottom of the camera.
  • Locate the cover on the bottom of the camera.

  • Slide the cover towards the back of the camera.

  • Be careful—the battery can slide out on its own.

Yorum Ekle

Carefully remove the exposed battery.
  • Carefully remove the exposed battery.

    • If it is difficult to remove, flip over the camera and the battery will slide out.

Yorum Ekle

  • Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver.

Yorum Ekle

  • Pull the two halves of the camera apart.

  • Place the two halves down with the insides facing you.

Yorum Ekle

  • Find the two clips holding the motherboard to the black lens box.

  • Slide the plastic opening tool in between the ribbon and the black part of the clip, then flip it. (If difficult, your fingernail can also be used)

Yorum Ekle

  • After releasing the clips, pull out black lens box.

Yorum Ekle

  • Use the plastic opening tool to flip the clip.

Yorum Ekle

  • Grab the white part and slide it to the right until it clicks.

    • This may require some force.

  • Pull out the flash.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Paul Elrich

Üyelik tarihi: 12-04-2012

15 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 7-35, Maness Spring 2012 Cal Poly, Team 7-35, Maness Spring 2012 üyesi

CPSU-MANESS-S12S7G35

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 515