Giriş

This could be a solution to the buttons on the back of the camera not working. This is an easy replacement. Just be careful with the ribbons.

  1. Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom. Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom. Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.
    • Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.

  2. Take off the front part of the case with a plastic opening tool. Take off the front part of the case with a plastic opening tool. Take off the front part of the case with a plastic opening tool.
    • Take off the front part of the case with a plastic opening tool.

  3. Pro Tech Toolkit içeren veya $100,00tüm siparişlerde ücretsiz kargo!

    Mağazamıza Göz Atın
  4. Pull off the two silver side pieces on the left and right sides. Pull off the two silver side pieces on the left and right sides.
    • Pull off the two silver side pieces on the left and right sides.

  5. Remove the main back piece. It should easily lift off. Remove the main back piece. It should easily lift off.
    • Remove the main back piece. It should easily lift off.

  6. Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease. Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease. Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.
    • Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.

  7. Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard. Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard.
    • Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Douglas Howe

Üyelik tarihi: 08-01-2015

474 İtibar

4 adet Kılavuz yazıldı

Takım

USF Tampa, Team 9-4, Blackwell Winter 2015 USF Tampa, Team 9-4, Blackwell Winter 2015 üyesi

USFT-BLACKWELL-W15S9G4

3 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 288