Eşyalarını Tamir Et Topluluk Mağaza

Sony Cyber-shot DSC-WX100 Image Sensor Replacement

Giriş

This guide will allow the reader to how to disassemble the DSC-WX100 and get to its image sensor.

Neye ihtiyacın var

  1. Sony Cyber-shot DSC-WX100 Image Sensor Replacement, Battery: adım 1, 1 resimden 1.

    • Open the flap indicated to allow access to the battery slot.

    • The gray switch indicated has to be moved to the right in order to release the flap.

    Düzenle

  2. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 2, 1 resimden 1.

    • If the old battery is still in the slot, then make sure the camera is turned off prior to removal.

    • If there is a battery currently in the slot, remove by first pulling downwards on the blue component. This will allow you to remove the battery from the slot.

    Düzenle

  3. Sony Cyber-shot DSC-WX100 Image Sensor Replacement, Outer Casing: adım 3, 3 resimden 1. Sony Cyber-shot DSC-WX100 Image Sensor Replacement, Outer Casing: adım 3, 3 resimden 2. Sony Cyber-shot DSC-WX100 Image Sensor Replacement, Outer Casing: adım 3, 3 resimden 3.

    • Remove all of the 1mm screws using a Philips #000 Screwdriver.

    • Remover the rest of the screws (2mm) from the camera covers using a Phillips #000 Screwdriver.

    Düzenle

  4. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 4, 2 resimden 1. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 4, 2 resimden 2.

    • Use the plastic opening tool to gently remove the front and back plates of the camera.

    Düzenle

  6. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 5, 2 resimden 1. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 5, 2 resimden 2.

    • Use a plastic opening tool to gently release the two indicated tabs.

    Düzenle

    • Pull up on the lower end of the plate. Lift it so that the plate is uninhibited by the indicated bump.

    • Pull away from the camera at the end of the metal plate with the blue circuits to then remove the plate from the rest of the camera.

    • For help with this step, refer to the video.

    Düzenle

  8. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 7, 3 resimden 1. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 7, 3 resimden 2. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 7, 3 resimden 3.

    • Remove this screw (1mm) with the Phillips #000 Screwdriver.

    • Gently lift the LCD screen component from the metal plate.

    • Remove the metal plate that was underneath the LCD screen from the camera.

    Düzenle

  9. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 8, 3 resimden 1. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 8, 3 resimden 2. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 8, 3 resimden 3.

    • Peel back the copper sheet.

    • Unscrew the three marked screws (2mm) using a Phillips #000 Screwdriver.

    • Remove the panel attached by said screws.

    Düzenle

  10. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 9, 1 resimden 1.

    • Peel back both the copper sheet and the black tape underneath the panel to expose the connection port.

    Düzenle

  11. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 10, 3 resimden 1. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 10, 3 resimden 2. Sony Cyber-shot DSC-WX100 Image Sensor Replacement: adım 10, 3 resimden 3.

    • Use a plastic opening tool to pry the black bar upwards.

    • Pull the image sensor out after the black tab is released.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Yazar

2 tane daha katılımcı ile

Matthew

Üyelik tarihi: 03/18/15

583 İtibar

4 adet Kılavuz yazıldı

Rozetler: 11

+8 tane daha rozet

Ekip

Michigan Tech, Team 1-9, Lauer Spring 2015 Michigan Tech, Team 1-9, Lauer Spring 2015 üyesi

MTU-LAUER-S15S1G9

2 Üyeler

6 adet Kılavuz yazıldı

Bir Yorum

thanks a lot very helpfull.

could you precise( in remounting phase) that it is necessary to take care of the position of the back slider (photo/pano/video) before screwing, it will avoid to dismount again…….

regards

Olivier TRIFT - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 1

Her zaman: 886