Giriş

If the device is on but nothing shows up on the screen, the screen may need to be replaced.

Parçalar

Hiçbir parçaya gerek yok.

  1. Use your hand to remove the small back cover.
    • Use your hand to remove the small back cover.

    Yorum Ekle

  2. Remove the two 0.473" pan head screws as shown circled in the picture
    • Remove the two 0.473" pan head screws as shown circled in the picture

    Yorum Ekle

    • The screen should now detach from the main device.

    • The screen will still be connected by the wires

    Yorum Ekle

    • Remove the wires attached to the white base by using the tweezers

    Yorum Ekle

    • Do the same with the wires attached to the black base.

    Yorum Ekle

    • The screen should now be completely separated from the main device.

    Yorum Ekle

    • Remove the four rubber feet and the screws indicated by the blue circles

    • Remove the two exposed screws indicated by the two orange circles on the left side

    • Pull back the cables until the screw (indicated by the red dot) is visible

    Yorum Ekle

    • Using the spudger, separate the top and bottom covers.

    Yorum Ekle

    • Identify the gray back of the screen.

    Yorum Ekle

    • Remove the screws.

    Yorum Ekle

    • Remove the metal plates.

    Yorum Ekle

    • Using spudger, push the lock clips to unlock the ribbon cable.

    • Using tweezers, pull the connector loose.

    Yorum Ekle

    • Place your hand on the front of the screen and push upwards.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 başka kişi bu kılavuzu tamamladı.

Oliver Woolsoncroft

Üyelik tarihi: 20-01-2012

69 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 11-21, Maness Winter 2012 Cal Poly, Team 11-21, Maness Winter 2012 üyesi

CPSU-MANESS-W12S11G21

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 14

Her zaman: 2,214