Ana içeriğe geç

Bu kılavuzda güncel değişiklikler var. En son onaylanmamış sürüme geçin.

Sony NEX-7 LCD Assembly Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Neye ihtiyacın var

  1. Sony NEX-7 LCD Assembly Replacement, LCD Assembly: adım 1, 1 resimden 1.
    • Remove the two 3/32" #00 screws located next to the viewfinder using the Phillips #00 screwdriver.

  2. Sony NEX-7 LCD Assembly Replacement: adım 2, 1 resimden 1.
    • Remove the two 5/32" #00 screws from the right side of the camera below the D ring using the Phillips #00 screwdriver.

  3. Sony NEX-7 LCD Assembly Replacement: adım 3, 1 resimden 1.
    • Remove two more 3/32" #00 screws from the bottom of the camera using the Phillips #00 screwdriver.

  4. Sony NEX-7 LCD Assembly Replacement: adım 4, 1 resimden 1.
    • Remove two more 3/32" #00 screws from the metal bracket on the left side of the camera using the Phillips #00 screwdriver.

  5. Sony NEX-7 LCD Assembly Replacement: adım 5, 1 resimden 1.
    • Unplug the orange ribbon cable on the top right of the camera next to the metal bracket by applying tweezers to the tabs on either side of the plug.

  6. Sony NEX-7 LCD Assembly Replacement: adım 6, 1 resimden 1.
    • Before pulling off the assembly, fold the rightmost tab of the flexible circuit board away from the metal bracket.

  7. Sony NEX-7 LCD Assembly Replacement: adım 7, 2 resimden 1. Sony NEX-7 LCD Assembly Replacement: adım 7, 2 resimden 2.
    • The LCD assembly is attached with a concealed ribbon cable, so be gentle when you remove it.

    • The D ring brackets on either side are not attached, only held in mechanically. Once the LCD assembly starts to come out, they will detach.

    • Pull on the D rings on either side of the camera to start removing the assembly.

    • Once the brackets are cleared from black shell, take them off and set them aside.

    • Continue to remove the screen assembly.

  8. Sony NEX-7 LCD Assembly Replacement: adım 8, 1 resimden 1.
    • With the camera face down, move the assembly away from you to get a clear view of the wide ribbon cable.

    • Unplug the cable by applying tweezers to the tabs on either side of the plug.

    • Set the LCD assembly aside.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Jay Miley

Üyelik tarihi: 04/22/14

5.042 İtibar

13 adet Kılavuz yazıldı

Ekip

Cal Poly, Team 10-55, Amido Spring 2014 Cal Poly, Team 10-55, Amido Spring 2014 üyesi

CPSU-AMIDO-S14S10G55

4 Üyeler

31 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 64