Tools you will need is the Phillips #00 precision screwdriver, Plastic Opening Tools, and tweezers. Insert plastic opening tool in the corner of device and slide along edges to separate adhesive. Remove cover
  • Tools you will need is the Phillips #00 precision screwdriver, Plastic Opening Tools, and tweezers.

  • Insert plastic opening tool in the corner of device and slide along edges to separate adhesive.

  • Remove cover

  • Disconnect battery, to avoid electric shock, by pulling up on the white plastic as shown by the orange box.

Yorum Ekle

Locate the volume module.
  • Locate the volume module.

  • Remove both screws using the Philips screwdriver.

Yorum Ekle

Once both screws are removed grab the tweezers.
  • Once both screws are removed grab the tweezers.

  • Then lift up on the module.

Yorum Ekle

Find the electrical tape connecting the module to the motherboard
  • Find the electrical tape connecting the module to the motherboard

  • Carefully pull out the electrical tape horizontally and remove the volume module from the device.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Martin Luna

Üyelik tarihi: 24-09-2014

1.504 İtibar

5 adet Kılavuz yazıldı

Takım

USF Tampa, Team 15-6, Remmell Fall 2014 USF Tampa, Team 15-6, Remmell Fall 2014 üyesi

USFT-REMMELL-F14S15G6

3 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 6

Son 30 Gün: 16

Her zaman: 1,739