Eşyalarını Tamir Et Topluluk Mağaza

Spark Test

Giriş

Follow this guide to use a spark tester to test the ignition system on a 2019 Echo Power Pruner model PPT-2620.

This procedure requires two people.

Neye ihtiyacın var

  1. Spark Test, Safety precautions: adım 1, 2 resimden 1. Spark Test, Safety precautions: adım 1, 2 resimden 2.

    • Flip the power switch into the STOP position.

    • Make sure the engine is cool to the touch before proceeding.

    Düzenle

  2. Spark Test, Remove the muffler cover: adım 2, 2 resimden 1. Spark Test, Remove the muffler cover: adım 2, 2 resimden 2.

    • Use a T27 Torx screwdriver to remove the two screws securing the bottom of the muffler cover to the motor.

    Düzenle

  3. Spark Test: adım 3, 3 resimden 1. Spark Test: adım 3, 3 resimden 2. Spark Test: adım 3, 3 resimden 3.

    • Tilt the muffler cover up, hinging along the top edge, until it can be removed from the motor cover.

    • Remove the muffler cover.

    Düzenle

  5. Spark Test: adım 4, 2 resimden 1. Spark Test: adım 4, 2 resimden 2.

    • Pull the spark plug boot straight off of the spark plug.

    Düzenle

  6. Spark Test, Connect the spark tester: adım 5, 2 resimden 1. Spark Test, Connect the spark tester: adım 5, 2 resimden 2.

    • Connect the spark plug boot to the left terminal of the ignition checker.

    Düzenle

  7. Spark Test: adım 6, 1 resimden 1.

    • Connect the ignition checker alligator clip to a metal surface on the motor to ground the accessory cord.

    Düzenle

  8. Spark Test: adım 7, 1 resimden 1.

    • Set the spark gap to 6 mm by turning the spark gap adjustment knob counterclockwise.

    • Do not set the spark gap unnecessarily wide—a high voltage may damage the ignition coil.

    Düzenle

  9. Spark Test: adım 8, 1 resimden 1.

    • Flip the power switch into the ON position.

    Düzenle

  10. Spark Test: adım 9, 3 resimden 1. Spark Test: adım 9, 3 resimden 2. Spark Test: adım 9, 3 resimden 3.

    • Hold the spark tester by the handle on the bottom. Do not touch the terminals or spark window while the test is being conducted.

    • Watch for a spark in the spark window while a second person pulls the starter to crank the engine.

    • Consult the ignition checker instruction manual to troubleshoot the device.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

1 tane daha katılımcı ile

Sam Omiotek

Üyelik tarihi: 02/25/19

72.947 İtibar

288 adet Kılavuz yazıldı

Rozetler: 35

+32 tane daha rozet

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 3

Son 30 gün: 8

Her zaman: 279