1. Locate the horizontal grip located on the back cover of the phone.
    • Locate the horizontal grip located on the back cover of the phone.

    • Slide the back cover down and off of the phone.

    Yorum Ekle

  2. Insert a plastic opening tool into the battery release point located above the battery.
    • Insert a plastic opening tool into the battery release point located above the battery.

    • Pull outwards in order to release the battery.

    Yorum Ekle

    • Locate the 5 screws holding the body of the phone together.

    • The top screw will have a plastic cover, remove it using tweezers.

    • Using a Philips head screwdriver, twist counterclockwise to remove the screws.

    • Take special care with the screw located at the top of the phone. It is smaller and more likely to be damaged or improperly attached.

    Yorum Ekle

    • Lift the back cover starting at the bottom of the phone.

    Yorum Ekle

    • Remove the back cover completely from the phone.

    Yorum Ekle

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Locate the clamp at bottom right side of the Circuit Board.

    • Pull the circuit board from the phone being cautious to pull out underneath the clamp.

    Yorum Ekle

    • Locate the ribbon connecting the circuit board to the phone display.

    • Using the spudger, disconnect the ribbon connecting the phone's display and the circuit board.

    • Remove the circuit board

    Yorum Ekle

    • Locate the two rubber circles covering the screws.

    • Remove the rubber covers using tweezers.

    • Using the Phillips head screwdriver, unscrew and remove the two screws.

    Yorum Ekle

    • Close the phone and gently pull outwards from the bottom left portion of the phone cover.

    • Take care not to do this with too much force, as it could crack the cover.

    • Completely remove the cover from the phone.

    Yorum Ekle

    • Locate the front music buttons.

    • Remove the music control buttons on the face of the phone.

    Yorum Ekle

    • While grasping the top and bottom sections torque the pieces until the indicated hinge has popped out. The two sections of the phone are now able to separate.

    • Make sure the right side of the hinge is removed first and not the left as you will likely damage the ribbon connection.

    Yorum Ekle

    • Locate the two speakers. Using a spudger disconnect the speakers from the assembly.

    • Lift the screen assembly from the casing.

    • The screen assembly is completely removed to allow for easier access to the speaker connections when performing further repairs on the speakers.

    Yorum Ekle

    • Use a pair of tweezers to disconnect the speaker wires from the circuit board. Note that the soldered connection must be broken for this to occur.

    Yorum Ekle

Sonuç

To reassemble your device, re-solder the speaker wires to the circuit board and follow the rest of the instructions in reverse order.

Jonathan Flowers

Üyelik tarihi: 18-10-2013

607 İtibar

6 adet Kılavuz yazıldı

Takım

Clemson, Team 14-7, Benson Fall 2013 Clemson, Team 14-7, Benson Fall 2013 üyesi

CLEM-BENSON-F13S14G7

3 Üyeler

15 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 197