Ana içeriğe geç

Sphero Ollie Battery Replacement

Neye ihtiyacın var

  1. Sphero Ollie Battery Replacement, Tires and Hubcaps: adım 1, 1 resimden 1.
    • Firmly grasp Ollie in one hand.

    • Remove the blue rubber tire in a peeling motion with your opposite hand.

  2. Sphero Ollie Battery Replacement: adım 2, 2 resimden 1. Sphero Ollie Battery Replacement: adım 2, 2 resimden 2.
    • Continue to firmly hold Ollie in one hand.

    • Use a Plastic Opening Tool to gently pry off the hubcap.

    • Avoid inserting the Plastic Opening Tool into the empty holes, but instead use the tool near the tabs holding the hubcap in.

    • Do not aim the hubcap towards another person as it may pop off with force.

  3. Sphero Ollie Battery Replacement, Motherboard: adım 3, 1 resimden 1.
    • Loosen and remove the 10mm screw on each side of the device using a JIS 1 screwdriver tip.

    • Remove the plastic tire frame from the device

  4. Sphero Ollie Battery Replacement: adım 4, 2 resimden 1. Sphero Ollie Battery Replacement: adım 4, 2 resimden 2.
    • Loosen and remove the four 10mm Screws on the underside of the device using a JIS 1 tip.

    • Firmly grasp the bottom of the device and pull the top half of the outer case off of the bottom.

  5. Sphero Ollie Battery Replacement: adım 5, 2 resimden 1. Sphero Ollie Battery Replacement: adım 5, 2 resimden 2.
    • Loosen and remove the 10mm screws holding the blue tooth connector as well as the two 1 10 screws holding the motherboard to the case using the JIS #1 screwdriver

    • Loosen and remove the 10mm screws holding the antenna to the case.

    • Gently remove mother board from the case with an upward motion.

  6. Sphero Ollie Battery Replacement, Battery: adım 6, 3 resimden 1. Sphero Ollie Battery Replacement, Battery: adım 6, 3 resimden 2. Sphero Ollie Battery Replacement, Battery: adım 6, 3 resimden 3.
    • After you have removed the motherboard, use a JIS #1 screwdriver to remove the four 10mm Screws holding in the cog shields.

    • Next, you want to pull apart the clips (two on each side) holding the top piece of the shield to the frame.

    • Then, once you have freed the cogs, you can lift the cog and remove it from the frame.

    • To completely remove the cog shield out of the way, carefully remove the black pin connectors from the slot in the shield.

  7. Sphero Ollie Battery Replacement: adım 7, 2 resimden 1. Sphero Ollie Battery Replacement: adım 7, 2 resimden 2.
    • Once you have removed the cog out of the way, you can then pinch the clip to access the battery.

    • To remove the battery, simply pull on it with slight force as it is held tight by adhesives.

Sonuç

To reassemble your device, follow these instructions in reverse order.

12 farklı kişi bu kılavuzu tamamladı.

Krystal Hedrick

Üyelik tarihi: 10/30/17

361 İtibar

3 adet Kılavuz yazıldı

Ekip

UW Tacoma, Team S1-G3, Rose Fall 2017 UW Tacoma, Team S1-G3, Rose Fall 2017 üyesi

UWT-ROSE-F17S1G3

4 Üyeler

10 adet Kılavuz yazıldı

7 Yorum

How do you buy a new battery, where do you get them from?

Alex - Yanıt

Alex,

Amazon (Uxcell Power Supply DC 3.7 V 1000 MAh 803040 Li-ion rechargeable lithium Polymer Li- Po Battery

Keith Johnson -

Yes I need to find a battery as well

Keith Johnson - Yanıt

Need a battery email me terrys2207@yahoo.co.uk

Terry Saunders - Yanıt

Can I get a motherboard replaced in ollie. Please help me with reply to my email sgandham1980@icloud.com

gandham santhosh - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 19

Son 30 gün: 68

Her zaman: 7,611