Eşyalarını Tamir Et Topluluk Mağaza

TDK Life on Record A33 Speaker Replacement

Giriş

The middle speaker can be taken apart and replaced if needed. A thin tool is required to take off the speaker guard as well as a Phillip's head screwdriver and a soldering iron to remove the speaker. Be careful when soldering the wires in the speaker.

Neye ihtiyacın var

  1. TDK Life on Record A33 Speaker Replacement, Speaker Guard: adım 1, 1 resimden 1.

    • Push the nylon or metal spudger in the corner of the speaker guard.

    Düzenle

  2. TDK Life on Record A33 Speaker Replacement: adım 2, 1 resimden 1.

    • Slowly lift the speaker up enough so that you can slide around the speaker guard.

    Düzenle

  3. TDK Life on Record A33 Speaker Replacement: adım 3, 2 resimden 1. TDK Life on Record A33 Speaker Replacement: adım 3, 2 resimden 2.

    • Slide the nylon or metal spudger all around the speaker guard.

    Düzenle

  5. TDK Life on Record A33 Speaker Replacement: adım 4, 1 resimden 1.

    • Remove the speaker guard. You can now replace the speaker guard on your TDK Life on Record A33.

    Düzenle

  6. TDK Life on Record A33 Speaker Replacement, Speaker: adım 5, 2 resimden 1. TDK Life on Record A33 Speaker Replacement, Speaker: adım 5, 2 resimden 2.

    • Remove all (4) 3mm screws in the middle speaker using a Phillip's head screwdriver.

    • You can also remove the speakers on the left and right.

    Düzenle

  7. TDK Life on Record A33 Speaker Replacement: adım 6, 2 resimden 1. TDK Life on Record A33 Speaker Replacement: adım 6, 2 resimden 2.

    • Do not rip the wires inside the speaker when trying to open the middle speaker on the device.

    • Create an opening in the speaker by holding the device up and carefully grabbing the side of the speaker that pops out.

    Düzenle

  8. TDK Life on Record A33 Speaker Replacement: adım 7, 2 resimden 1. TDK Life on Record A33 Speaker Replacement: adım 7, 2 resimden 2.

    • Wear safety goggles and have something to absorb the smoke from the soldering iron just in case.

    • Do not burn the wires of the speaker.

    • Remove the solder that connects the wires to the speaker. You should be able to now remove the speaker and replace it.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Yazar

2 tane daha katılımcı ile

Matthew Phou

Üyelik tarihi: 10/20/15

448 İtibar

2 adet Kılavuz yazıldı

Rozetler: 10

+7 tane daha rozet

Ekip

UMass Dartmouth, Team 4-2, Catania Fall 2015 UMass Dartmouth, Team 4-2, Catania Fall 2015 üyesi

UMASSD-CATANIA-F15S4G2

4 Üyeler

5 adet Kılavuz yazıldı

3 Yorum

Where can I buy the woofer?

stevealvarado54 - Yanıt

Really, stevealvarado! What's The point of taking this all apart if you don't have a replacement to put in?

Van Moon - Yanıt

If l need a second opinion about which speaker is blown, who or where can can l get it diagnosed?

Tony - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 3

Son 30 gün: 25

Her zaman: 4,420