Eşyalarını Tamir Et Topluluk Mağaza
Onarım Topluluğuna Katılın - Hesap Oluşturun

Tara Handle Replacement

Giriş

Follow this guide to remove the handle of a Tara pump for replacement or repair.

  1. Tara Handle Replacement, Handle: adım 1, 1 resimden 1.

    • Before performing any repairs, perform a water test on the pump by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.

    • Use a Tara tool to loosen the jam nuts on either side of the pump.

    • The bolts do not need to be loosened or removed, only the nuts need to be loosened.

    Düzenle

  2. Tara Handle Replacement: adım 2, 3 resimden 1. Tara Handle Replacement: adım 2, 3 resimden 2. Tara Handle Replacement: adım 2, 3 resimden 3.

    • Unscrew the lock bolts about half an inch.

    • The bolts do not need to be removed from the base.

    Düzenle

  3. Tara Handle Replacement: adım 3, 2 resimden 1. Tara Handle Replacement: adım 3, 2 resimden 2.

    • Pull the plastic bushing and handle straight up out of the pump.

    • If the bushing doesn't come up, loosen the lock bolts further.

    Düzenle

  5. Tara Handle Replacement: adım 4, 2 resimden 1. Tara Handle Replacement: adım 4, 2 resimden 2.

    • Lift up the handle and riser main until the joint between the two is at a comfortable height to work on.

    Düzenle

  6. Tara Handle Replacement: adım 5, 3 resimden 1. Tara Handle Replacement: adım 5, 3 resimden 2. Tara Handle Replacement: adım 5, 3 resimden 3.

    • Loosen the jam nut beneath the pump handle using the Tara tool.

    Düzenle

  7. Tara Handle Replacement: adım 6, 2 resimden 1. Tara Handle Replacement: adım 6, 2 resimden 2.

    • Unscrew the pump handle from the top of the riser main.

    • Make sure someone is tightly holding the lower portion of the riser main to prevent losing it down the well.

    Düzenle

  8. Tara Handle Replacement: adım 7, 2 resimden 1. Tara Handle Replacement: adım 7, 2 resimden 2.

    • Lift and remove the handle from the pump. Store the handle in a sanitary place to prevent contamination.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

5 tane daha katılımcı ile

Sam Goldheart

Üyelik tarihi: 10/18/12

477.143 İtibar

538 adet Kılavuz yazıldı

Rozetler: 49

+46 tane daha rozet

Ekip

iFixit iFixit üyesi

Staff

123 Üyeler

25.548 adet Kılavuz yazıldı

0Kılavuz Yorumları

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 gün: 18

Son 30 gün: 54

Her zaman: 424