Ana içeriğe geç

What you need

  1. Testing Patagonia Waders For Leaks, Testing Patagonia Waders For Leaks: adım 1, 3 resimden 1. Testing Patagonia Waders For Leaks, Testing Patagonia Waders For Leaks: adım 1, 3 resimden 2. Testing Patagonia Waders For Leaks, Testing Patagonia Waders For Leaks: adım 1, 3 resimden 3.
    • Set up a ladder in a level place outside that you don't mind getting wet.

    • Turn the waders inside out.

    • Clip the waders to the ladder.

  2. Testing Patagonia Waders For Leaks: adım 2, 3 resimden 1. Testing Patagonia Waders For Leaks: adım 2, 3 resimden 2. Testing Patagonia Waders For Leaks: adım 2, 3 resimden 3.
    • Put the hose into the waders.

    • Slide the hose into one leg of the waders.

  3. Testing Patagonia Waders For Leaks: adım 3, 2 resimden 1. Testing Patagonia Waders For Leaks: adım 3, 2 resimden 2.
    • Turn on the hose and begin to fill the waders.

    • Be sure to pay attention because the large amount of water may tip the ladder. If needed, weigh the back side of the ladder down to prevent it from tipping.

  4. Testing Patagonia Waders For Leaks: adım 4, 3 resimden 1. Testing Patagonia Waders For Leaks: adım 4, 3 resimden 2. Testing Patagonia Waders For Leaks: adım 4, 3 resimden 3.
    • Watch for leaks. When you find a leak, mark it with a permanent marker.

    • Repeat this process for the other leg, marking all the leaks you find.

    • Dump the water out and allow the waders to dry completely before you continue.

Bitiş Çizgisi

Brittany McCrigler

Üyelik tarihi: 05-03-2012

87.837 İtibar

132 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 1

Son 30 gün: 4

Her zaman: 170