Ana içeriğe geç

Parçalar

Hiçbir parça belirtilmedi.

  1. Power down the TiVo and detach the power cable from the rear of the unit.
    • Power down the TiVo and detach the power cable from the rear of the unit.

    • Wait 5 minutes for the unit to fully discharge before proceeding to the next step.

  2. Remove the five T10 screws from the rear of the case using the Torx screwdriver.
    • Remove the five T10 screws from the rear of the case using the Torx screwdriver.

  3. Lift up and pull back the outer casing towards the rear of the unit. Lift up and pull back the outer casing towards the rear of the unit.
    • Lift up and pull back the outer casing towards the rear of the unit.

  4. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  5. Carefully remove the ribbon cable from the power supply. Hold the ribbon on both sides and pull up. Carefully remove the ribbon cable from the power supply. Hold the ribbon on both sides and pull up.
    • Carefully remove the ribbon cable from the power supply. Hold the ribbon on both sides and pull up.

  6. Disconnect the hard drive power cable. Firmly grip the white power connector and pull away from the hard drive.
    • Disconnect the hard drive power cable. Firmly grip the white power connector and pull away from the hard drive.

    • Do not pull on the power cables when disconnecting power connector.

  7. Rotate the device 180 degrees and remove the two T10 screws from the power supply board.
    • Rotate the device 180 degrees and remove the two T10 screws from the power supply board.

  8. Remove the four plastic standoffs. Use pliers to squeeze the plastic pieces on the head together. Carefully press down on the standoff and pull up on the power supply.
    • Remove the four plastic standoffs.

    • Use pliers to squeeze the plastic pieces on the head together. Carefully press down on the standoff and pull up on the power supply.

  9. Lift the power supply out of the unit. Do not touch any circuit elements or capacitors on the power supply, as they may hold a charge after the unit has been shut off.
    • Lift the power supply out of the unit.

    • Do not touch any circuit elements or capacitors on the power supply, as they may hold a charge after the unit has been shut off.

Sonuç

To reassemble your device, follow these instructions in reverse order.

2 farklı kişi bu kılavuzu tamamladı.

Svyatoslav Markeyev

Üyelik tarihi: 16-04-2010

135 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 33-79, Johann Spring 2010 Cal Poly, Team 33-79, Johann Spring 2010 üyesi

CPSU-JOHANN-S10S33G79

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 4

Her zaman: 4,876