Parçalar

Hiçbir parçaya gerek yok.

  1. Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.
    • Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.

    Yorum Ekle

  2. With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
    • With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.

    • The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.

    Yorum Ekle

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • If needed, use the flathead screwdriver to gently pry the panel from the phone.

    • Using your fingers, lift the panel from the device.

    Yorum Ekle

    • Use your fingers to gently detach the ribbon wire from the logic board.

    Yorum Ekle

    • Use the flathead screwdriver to pry the logic board and keypad from the device.

    Yorum Ekle

    • Use your thumb to peel the keypad from the device.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Christopher

Üyelik tarihi: 22-04-2010

90 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 16-6, Maness Spring 2010 Cal Poly, Team 16-6, Maness Spring 2010 üyesi

CPSU-MANESS-S10S16G6

4 Üyeler

16 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 2,504