Start by first removing the battery. Move the first release switch to the right position.
  • Start by first removing the battery.

  • Move the first release switch to the right position.

  • Move the second release switch to the right position while pulling the battery towards the top of the netbook.

Yorum Ekle

Using the bit driver and a Phillips #0 bit, remove the three circled screws, 5 mm in length.
  • Using the bit driver and a Phillips #0 bit, remove the three circled screws, 5 mm in length.

Yorum Ekle

While holding the top of the netbook, flip the netbook over. While holding the top of the netbook, flip the netbook over.
  • While holding the top of the netbook, flip the netbook over.

Yorum Ekle

Carefully lift off the power bar assembly for access to the button and receiver. Carefully lift off the power bar assembly for access to the button and receiver.
  • Carefully lift off the power bar assembly for access to the button and receiver.

Yorum Ekle

Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body. Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body. Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body.
  • Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body.

Yorum Ekle

Reach under the keyboard and disconnect the electrical connection. Lift the keyboard assembly out and away from the netbook.
  • Reach under the keyboard and disconnect the electrical connection.

  • Lift the keyboard assembly out and away from the netbook.

Yorum Ekle

Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool. Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool.
  • Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool.

Yorum Ekle

Remove this electrical connection with tweezers. Use a spudger to gently pry the bezel from retaining clips.
  • Remove this electrical connection with tweezers.

  • Use a spudger to gently pry the bezel from retaining clips.

  • This will allow the keyboard bezel to lift off of the body.

Yorum Ekle

Use tweezers to remove the electrical connection to the old speaker assembly.
  • Use tweezers to remove the electrical connection to the old speaker assembly.

Yorum Ekle

Use a bit driver and a Phillips #0 bit to remove the two retaining screws on the speaker assembly. Lift out the old speaker assembly.
  • Use a bit driver and a Phillips #0 bit to remove the two retaining screws on the speaker assembly.

  • Lift out the old speaker assembly.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

Üyelik tarihi: 18-10-2013

943 İtibar

9 adet Kılavuz yazıldı

Takım

Clemson, Team 14-2, Benson Fall 2013 Clemson, Team 14-2, Benson Fall 2013 üyesi

CLEM-BENSON-F13S14G2

3 Üyeler

9 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 2

Her zaman: 324