Ana içeriğe geç
  1. Use a spudger to remove the small rubber screw coverings above each retaining screw. Use the bit driver with a Phillips #0 bit to remove the two 5 mm screws securing the screen bezel.
    • Use a spudger to remove the small rubber screw coverings above each retaining screw.

    • Use the bit driver with a Phillips #0 bit to remove the two 5 mm screws securing the screen bezel.

  2. Using a spudger, gently pry the screen bezel to the condition of the photograph. For this procedure, it is not necessary to completely removal screen bezel so in order to reduce work, bezel is just partially removed. For this procedure, it is not necessary to completely removal screen bezel so in order to reduce work, bezel is just partially removed.
    • Using a spudger, gently pry the screen bezel to the condition of the photograph.

    • For this procedure, it is not necessary to completely removal screen bezel so in order to reduce work, bezel is just partially removed.

  3. MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now

    MacBook Pil Tamir Setleri

    Başlangıç $69.99

    Buy Now
  4. Using pliers, gently remove the electrical connection to the webcam by pulling the plug to the right (per orientation of the photo). Allow the removed wire to hang in place but make note of alignment with respect to webcam.
    • Using pliers, gently remove the electrical connection to the webcam by pulling the plug to the right (per orientation of the photo).

    • Allow the removed wire to hang in place but make note of alignment with respect to webcam.

    • This step is performed while holding down the bezel which is only partially detached.

  5. Use the spudger to pry each side of the webcam until it releases from its adhesive back. Use the spudger to pry each side of the webcam until it releases from its adhesive back. Use the spudger to pry each side of the webcam until it releases from its adhesive back.
    • Use the spudger to pry each side of the webcam until it releases from its adhesive back.

  6. Position the new webcam in the old webcam's position. The webcam must be carefully aligned in order to function properly with the bezel in place. Align the hole of the webcam assembly over the cylinder of the webcam stabilizer. Reconnect the electrical connection.
    • Position the new webcam in the old webcam's position. The webcam must be carefully aligned in order to function properly with the bezel in place. Align the hole of the webcam assembly over the cylinder of the webcam stabilizer.

    • Reconnect the electrical connection.

  7. Gently press the front bezel back into its original position. Using the bit driver and Phillips #0 bit, drive the two bezel retaining screws in to place. Cover the screws with the small covers with tweezers.
    • Gently press the front bezel back into its original position.

    • Using the bit driver and Phillips #0 bit, drive the two bezel retaining screws in to place.

    • Cover the screws with the small covers with tweezers.

Bitiş Çizgisi

Mason McCaskill

Üyelik tarihi: 18-10-2013

943 İtibar

9 adet Kılavuz yazıldı

Takım

Clemson, Team 14-2, Benson Fall 2013 Clemson, Team 14-2, Benson Fall 2013 üyesi

CLEM-BENSON-F13S14G2

3 Üyeler

9 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 1

Her zaman: 371