Giriş

This guide will go through the steps needed to install a new hard drive.

Parçalar

Hiçbir parçaya gerek yok.

  1. Turn the computer over onto its back.
    • Turn the computer over onto its back.

    Yorum Ekle

  2. Slide the lock on the left side to the unlock position.
    • Slide the lock on the left side to the unlock position.

    • Slide the lock on the right side to the unlock position until there is a clicking sound.

    Yorum Ekle

    • Remove the battery by sliding it out while both locks remain in the unlock position.

    Yorum Ekle

    • Turn the computer over onto the back.

    • Use a Phillips head screwdriver to remove the screw from the hard drive cover.

    • One 8.5 mm fine thread screw.

    • Lift and remove the cover.

    Yorum Ekle

    • Carefully remove the hard drive from the IDE cable by pulling on the black connector (do not pull the orange cable).

    Yorum Ekle

    • Remove the two gray rubber covers from both ends of the hard drive.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 başka kişi bu kılavuzu tamamladı.

Alison Wendt

Üyelik tarihi: 18-04-2013

78 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 21-51, Johann Spring 2013 Cal Poly, Team 21-51, Johann Spring 2013 üyesi

CPSU-JOHANN-S13S21G51

3 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 12

Her zaman: 1,643