Ana içeriğe geç

Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement

Neye ihtiyacın var

  1. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement, Battery: adım 1, 2 resimden 1. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement, Battery: adım 1, 2 resimden 2.
    • Power off your laptop before continuing.

    • Remove the following two 4mm screws with a Phillips #0 screwdriver.

  2. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement: adım 2, 1 resimden 1.
    • Slide the battery out towards you.

  3. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement, Bottom Case: adım 3, 1 resimden 1.
    • Remove the following twelve 4mm screws with a Phillips #0 screwdriver.

  4. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement: adım 4, 1 resimden 1.
    • Use a spudger to depress the six white clips connecting the plastic cover

  5. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement: adım 5, 1 resimden 1.
    Bu adımda kullanılan alet:
    Plastic Cards
    $2.99
    Satın Al
    • Run the spudger or a plastic card around the entire laptop to release the rest of the clips.

  6. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement: adım 6, 1 resimden 1.
    • Remove the cover and set to the side.

  7. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement, USB HDMI Audio Circuit Board: adım 7, 3 resimden 1. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement, USB HDMI Audio Circuit Board: adım 7, 3 resimden 2. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement, USB HDMI Audio Circuit Board: adım 7, 3 resimden 3.
    • Use the point end of the spudger to lift the clips that attach the two ribbons to the motherboard.

    • Pull out the ribbons from the motherboard.

  8. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement: adım 8, 2 resimden 1. Toshiba Satellite E45t-B4300 USB HDMI Audio Circuit Board Replacement: adım 8, 2 resimden 2.
    • Unscrew the 2mm screw with a Phillips #0 screwdriver.

    • Remove the circuit board.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Joshua Swanson

Üyelik tarihi: 02/20/17

701 İtibar

6 adet Kılavuz yazıldı

Ekip

USF Tampa, Team S2-G2, Sullivan Spring 2017 USF Tampa, Team S2-G2, Sullivan Spring 2017 üyesi

USFT-SULLIVAN-S17S2G2

3 Üyeler

12 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 gün: 6

Son 30 gün: 6

Her zaman: 301