Giriş

The CPU is what makes the computer work. If it is not working properly, the computer may not turn on or work in the way in needs to. This guide will show how to replace the CPU through a series of steps.

Unlock the right tab by sliding it to the right with your finger.
  • Unlock the right tab by sliding it to the right with your finger.

Yorum Ekle

Hold the left tab to the left using your left hand.
  • Hold the left tab to the left using your left hand.

Yorum Ekle

  • Remove the battery by placing your finger in the middle groove and lifting up.

Yorum Ekle

  • Remove the 13 Phillips #1 10mm screws from the backside of your computer using a Phillips #1 screwdriver.

Yorum Ekle

  • Remove the two Phillips #1 6mm screws from the backside of your computer using a Phillips #1 screwdriver.

Yorum Ekle

  • Remove the three 3mm screws from beneath the battery with a Phillips #1 screwdriver.

Yorum Ekle

  • Lift up the corner panel and remove it with your hand.

Yorum Ekle

  • Unscrew the four Phillips #1 3mm using a Phillips #1 screwdriver.

  • Unscrew the four 10mm screws around hard drive using a Phillips #1 screwdriver.

Yorum Ekle

  • To remove the hard drive case, first pull the black tab to the right.

  • Then pull the black tab up to remove the case.

Yorum Ekle

  • Remove the plastic strip above the "F" keys using the spudger by placing the small end of the spudger under the strip and lifting up.

Yorum Ekle

  • Remove the two Phillips #1 3mm screws underneath the plastic strip using a Phillips #1 screwdriver.

Yorum Ekle

  • Lift the keyboard up and remove it with your hands.

Yorum Ekle

  • Remove the five Phillips #1 10mm screws underneath the keyboard using a Phillips #1 screwdriver.

Yorum Ekle

  • Lift up the plastic panel and carefully disconnect the red and white ports.

  • Remove the panel

Yorum Ekle

  • Turn the laptop over so the bottom is facing up

  • Then remove the 3mm screw with a #1 screwdriver, located underneath the panel containing the wifi card and RAM

Yorum Ekle

  • Turn the laptop back over so the motherboard is facing up

  • Now slide the optical drive out of the computer by gently pulling it to the right

Yorum Ekle

  • Remove the two Phillips #1 3mm screws from the fan using a Phillips #1 screwdriver.

Yorum Ekle

  • Remove the two cables from the fan.

Yorum Ekle

  • LIft up on the fan and remove it from the computer.

Yorum Ekle

  • Remove the six 6mm screws from the motherboard with a #1 phillips screwdriver.

Yorum Ekle

  • Remove the lone 10mm screw from the motherboard with a phillips #1 screwdriver.

Yorum Ekle

  • Remove the motherboard with your hands by carefully lifting up and pulling out.

Yorum Ekle

  • Remove the four Phillips #1 6mm single coil pickup screws from the cooling unit and remove the cooling unit.

Yorum Ekle

  • Using a flathead screwdriver, undo the lock on the CPU with a half turn in the counterclockwise direction.

  • Remove the CPU by lifting up on the chip.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

9 başka kişi bu kılavuzu tamamladı.

NateJohnson

Üyelik tarihi: 26-01-2014

967 İtibar

5 adet Kılavuz yazıldı

Takım

Cal Poly, Team 9-26, Maness Winter 2014 Cal Poly, Team 9-26, Maness Winter 2014 üyesi

CPSU-MANESS-W14S9G26

4 Üyeler

5 adet Kılavuz yazıldı

Bir Yorum

Just be vary careful with unplugging any connectors. one false step and you could wind up with some more problems.

harh027213 - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 7

Son 30 Gün: 56

Her zaman: 2,093