Ana içeriğe geç
  1. Unscrew the three screws from the back panel with Phillips #0 screwdriver.
    • Unscrew the three screws from the back panel with Phillips #0 screwdriver.

    • Remove the back panel.

  2. Locate the two clips holding the RAM chip in place. Apply pressure to each clip, pulling them away from the RAM. One end of the RAM will pop out.
    • Locate the two clips holding the RAM chip in place.

    • Apply pressure to each clip, pulling them away from the RAM.

    • One end of the RAM will pop out.

  3. Gently pull RAM out as shown. Gently pull RAM out as shown.
    • Gently pull RAM out as shown.

  4. To intall a new stick of RAM, carefully insert it into into the RAM slot.
    • To intall a new stick of RAM, carefully insert it into into the RAM slot.

    • Gently push down on the RAM chip until it snaps securely into place.

Sonuç

To reassemble your device, follow these instructions in reverse order.

Michael Jensen

Üyelik tarihi: 18-04-2011

417 İtibar

6 adet Kılavuz yazıldı

Takım

Cal Poly, Team 4-3, Regan Spring 2011 Cal Poly, Team 4-3, Regan Spring 2011 üyesi

CPSU-REGAN-S11S4G3

5 Üyeler

6 adet Kılavuz yazıldı

0 Comments

Yorum Ekle

İstatistikleri Görüntüle:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 3

Her zaman: 2,568