Giriş

This guide will demonstrate how to dismantle and replace components of your computers display (screen).

  1. Using a bladed tool, gently pry up the display hinge cover.
    • Using a bladed tool, gently pry up the display hinge cover.

    Yorum Ekle

  2. After folding the display completely back, lift up on the display hinge cover and remove it.
    • After folding the display completely back, lift up on the display hinge cover and remove it.

    Yorum Ekle

  3. Yorum Ekle

    • Remove the black electrical tape covering the black-and-white antenna cable. There will be 2-3 pieces of tape.

    • After the tape has been removed, close the laptop display, flip the laptop over, and disconnect the black-and-white antenna cables from the WiFi Card.

    • Once the antenna cables are disconnected from the modem card, flip the laptop back over and open the display.

    Yorum Ekle

    • Remove the two screws securing the display hinges with a #1 size Phillips head screwdriver. It is recommended to keep the screws in a small cup so that you don't lose them.

    • Remove the four screws on the back of the laptop holding the screen in place with a #1 screwdriver. There are two on each side.

    Yorum Ekle

    • Remove the display's video connector by gently pulling up.

    • Remove the black-and-white antenna cable from the groove.

    • Your display can now be removed.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

3 başka kişi bu kılavuzu tamamladı.

Aryn Pauly

Üyelik tarihi: 29-04-2010

1 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 10-42, Garner Spring 2010 Cal Poly, Team 10-42, Garner Spring 2010 üyesi

CPSU-GARNER-S10S10G42

5 Üyeler

10 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 2

Son 30 Gün: 7

Her zaman: 7,817