Giriş

This is a repair guide for battery replacement.

To reach the battery, follow steps 1 through 3 in the Tungsten E Teardown

Yorum Ekle

Begin to pry up the battery.  It is fastened to the mother board using two sided tape.
  • Begin to pry up the battery. It is fastened to the mother board using two sided tape.

  • Caution: the battery is connected by two wires.

Yorum Ekle

Remove the battery
  • Remove the battery

  • Caution: Be careful not to tear the wires when removing battery.

Yorum Ekle

Using a soldering iron, disconnect the battery wires.
  • Using a soldering iron, disconnect the battery wires.

  • Note: the wires are soldered to the board.

Yorum Ekle

Take replacement battery and solder the wires to the board.
  • Take replacement battery and solder the wires to the board.

  • Take care to match wire colors as before.

  • Use double sided tape to attach battery firmly to board.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Kathleen Hix

Üyelik tarihi: 21-01-2010

49 İtibar

2 adet Kılavuz yazıldı

Takım

Cal Poly, Team 13-22, Maness Winter 2010 Cal Poly, Team 13-22, Maness Winter 2010 üyesi

CPSU-MANESS-W10S13G22

4 Üyeler

4 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 10

Son 30 Gün: 21

Her zaman: 5,643