Giriş
Use this guide to replace the battery in the Turtle Beach Pure Air Wireless Mouse. A failing battery can cause rapid power loss, failure to hold a charge, or the mouse not powering on, which you can confirm using the troubleshooting page.
Power off the device and follow all safety precautions, especially when handling damaged or swollen batteries.
Neye ihtiyacın var
-
-
-
Power off the mouse by moving the power switch to the center.
FixBot'a Sor
-
-
-
Peel back the mouse feet.
-
Remove the three 1.6mm screws using a JIS #000 screwdriver.
-
Remove the single 1.6mm screws using remove using a 1.3 mm hex screwdriver.
-
-
-
-
Disconnect the ribbon cable securing the upper shell to the motherboard.
-
Lift the locking clip to release the cable from its connector.
-
-
-
-
-
Carefully disconnect the battery clip from the motherboard socket by softly pulling the bottom of the clip.
-
-
-
Remove the two 1.6 mm screws on the middle left and lower right sides with a JIS000 screwdriver to disconnect the motherboard from the lower shell.
-
-
-
To reassemble your device, follow these instructions in reverse order.
Ekip
Austin Community College, Team 9-1, Watkins Spring 2026 Austin Community College, Team 9-1, Watkins Spring 2026 üyesi
AUSTINCC-WATKINS-S26S9G1
3 Üyeler
6 adet Kılavuz yazıldı
