Uniden D1483-3BK Circuit Board/Screen Replacement

Giriş

To complete this guide you will have to disassemble the handset and use a soldering iron to replace the circuit board. Other than the soldering process, the guide steps are medium in difficulty to complete. After completing this guide, users should have a fully operating, handset circuit board and screen.

Neye ihtiyacın var

Adım 1 Battery

Uniden D1483-3BK Circuit Board/Screen Replacement, Battery: adım 1, 1 resimden 1.

Set the phone with dial keys facing downward.

Düzenle

Adım 2

Slide the battery cover toward the bottom of the phone.
Lift and remove the back cover from the phone.

Düzenle

Adım 3

Remove the battery from its compartment.
Pinch the end of cord where the battery is attached to the phone and pull up gently.

Düzenle

Adım 4 Handset Case

Uniden D1483-3BK Circuit Board/Screen Replacement, Handset Case: adım 4, 2 resimden 1.

Uniden D1483-3BK Circuit Board/Screen Replacement, Handset Case: adım 4, 2 resimden 2.

Remove the two 9mm Phillips #1 screws in the battery compartment.

Düzenle

Adım 5

Uniden D1483-3BK Circuit Board/Screen Replacement: adım 5, 3 resimden 3.

Use the plastic opening tool to carefully separate the two halves of the case.
Slowly work around the entire case to fully separate the halves before pulling them apart.
Wires inside the case hold the two halves together, tearing these wires will lead to a need for additional repair.

Düzenle

Adım 6

Carefully remove the 9mm Phillips #1 screw from the top corner of the circuit board.

Düzenle

Adım 7

Carefully grasp either side of the circuit board and lift it straight out of the front half of the case.
Set the board in the lower half of the case.

Düzenle

Adım 8 Circuit Board/Screen

Uniden D1483-3BK Circuit Board/Screen Replacement, Circuit Board/Screen: adım 8, 1 resimden 1.

Set the circuit board on the table with the screen facing down.

Düzenle

Adım 9

Using the desoldering braid and soldering iron, remove the solder around the cable for the speaker.
When installing the new board, use the soldering iron and solder to reattach the speaker cables.

Düzenle