Eşyalarını Tamir Et Topluluk Mağaza

Vent/Bleed Coolant System on BMW E60/E90

Giriş

If you are unsure that your car's battery will be strong to handle 12-15 minutes of the venting process attach a battery charger!

Videoya Genel Bakış

    • Insert key in the dash or steering column.

    Düzenle

    • With foot OFF the brake (don't want to start the car), push the start button (headlamps and interior systems come on).

    Düzenle

    • Turn both temp dials as high as they will go and put the fan on the lowest setting.

    Düzenle

    • Push the accelerator pedal in for ten seconds then let go - you will hear the water pump cycle on.

    Düzenle

    • Set a timer for 12-15 minutes. In this time period, you will hear the water pump cycle on and off and coolant gurgling at the reservoir.

    Düzenle

    • After 12-15 minutes turn the car off, remove the reservoir cap and check the fluid - it should be slightly below where you started.

    Düzenle

    • Start your car. Watch your temperature. If the car will run without overheating you're done. If you will notice that the temperature is rising repeat these steps.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Bir başkası bu kılavuzu tamamladı.

Yazar

3 tane daha katılımcı ile

lifeoftech

Üyelik tarihi: 11/04/09

187 İtibar

1 Kılavuz yazıldı

Rozetler: 6

+3 tane daha rozet

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 13

Son 7 gün: 89

Son 30 gün: 496

Her zaman: 26,836