Giriş

The circuit board is home to many of the smaller parts of the Verizon M1424WR. These parts are soldered on to the circuit board, so in order to access them, you will need to remove the circuit board from the casing.

This router will have to be reauthenitcated with Verizon if you replace any WAN hardware or the whole board. Your new MAC address will not be approved.

Flip the device so that the bottom is facing up.
  • Flip the device so that the bottom is facing up.

Yorum Ekle

Insert the plastic-opening tool under the silver labeled casing.
  • Insert the plastic-opening tool under the silver labeled casing.

  • Carefully pry at different intervals around the silver labeled casing to separate the silver casing from the top and bottom casing.

Yorum Ekle

  • Unscrew the five 10-mm screws on the bottom of the router using a Phillips #0 screwdriver.

Yorum Ekle

  • Use a plastic-opening tool and pry the top casing from the bottom casing to expose the circuit board in the bottom half of the device.

Yorum Ekle

  • Locate the two 10-mm screws on either side of the circuit board.

  • Unscrew the two 10-mm screws using a Phillips #0 screwdriver.

  • Keep track of the red rubber washer you remove from underneath one of the screws.

Yorum Ekle

  • Lift the front of the circuit board up from the bottom casing.

Yorum Ekle

  • Pull the circuit board towards you until it is separate from the bottom casing.

Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Jeffrey Fox

Üyelik tarihi: 17-09-2014

305 İtibar

3 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 Gün: 2

Son 30 Gün: 6

Her zaman: 293