Ana içeriğe geç

Giriş

Over time, a refrigerator’s water filter becomes old and needs a replacement to keep your water clean and healthy. Luckily, replacing the water filter in a Whirlpool Side By Side Refrigerator model number WRS325FDAM04 is not difficult at all! All that is required is a new water filter that will be getting installed. This guide will show you a 7 easy step process that will help you get this job done.

Aletler

Parçalar

Hiçbir parça belirtilmedi.

  1. Pull the water filter door in the base grill open. Pull the water filter door in the base grill open. Pull the water filter door in the base grill open.
    • Pull the water filter door in the base grill open.

  2. As the door opens, the filter gets ejected out. When the filter is fully ejected, go ahead and pull the filter out. A towel is suggested as water might spill while pulling the old filter out.
    • As the door opens, the filter gets ejected out.

    • When the filter is fully ejected, go ahead and pull the filter out.

    • A towel is suggested as water might spill while pulling the old filter out.

  3. Get the new filter out of its packaging. Remove the covers from the O-rings while the O-rings still being in place.
    • Get the new filter out of its packaging.

    • Remove the covers from the O-rings while the O-rings still being in place.

  4. Align the new filter with the filter housing and insert filter into place. The arrows should be facing the same way.
    • Align the new filter with the filter housing and insert filter into place.

    • The arrows should be facing the same way.

  5. Close the filter cover door completely to snap the filter into to place correctly. You will hear a snap! Close the filter cover door completely to snap the filter into to place correctly. You will hear a snap! Close the filter cover door completely to snap the filter into to place correctly. You will hear a snap!
    • Close the filter cover door completely to snap the filter into to place correctly. You will hear a snap!

  6. Flush the water system by holding the water dispenser for 5 seconds and releasing for 5 seconds repeating this step until water begins to flow. After water flowing, get at least a total of 3 gallons dispensed in order to see full flushed water results.
    • Flush the water system by holding the water dispenser for 5 seconds and releasing for 5 seconds repeating this step until water begins to flow.

    • After water flowing, get at least a total of 3 gallons dispensed in order to see full flushed water results.

  7. Lastly you will need to reset the filter indicator by pushing the switch 5 times in a row. When the filter indicator is reset, the light should change from red to green. When the filter indicator is reset, the light should change from red to green.
    • Lastly you will need to reset the filter indicator by pushing the switch 5 times in a row.

    • When the filter indicator is reset, the light should change from red to green.

Sonuç

After flushing the water system completely, get ready to have some refreshing water with a cup of ice freshly made with the new installed water filter.

brenda lopez

Üyelik tarihi: 05-10-2021

198 İtibar

1 Kılavuz yazıldı

Takım

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 2

Son 7 gün: 24

Son 30 gün: 92

Her zaman: 253