Giriş

Use this guide to replace the outer case on your Nintendo Wii U GamePad.

  1. Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.
    • Face the GamePad down and unscrew the two Phillips #00 screws which are attached to the battery cover.

    • Lift up and remove the battery cover.

  2. With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.
    • With your finger on the battery connector, pull downwards toward the base of the GamePad to disconnect it.

    • Pull upwards from the bottom of the battery to release it.

    • Remove the ten 8.9mm Tri-wing Y1 screws hidden underneath square stickers.

    • Lift up the back plate.

    • The back plate is still connected by a cable to the motherboard.

    • Unplug the connector that connects the back plate to the motherboard.

    • Remove the back plate.

Sonuç

To reassemble your device, follow these instructions in reverse order.

8 başka kişi bu kılavuzu tamamladı.

Kim Arre

Üyelik tarihi: 11-01-2013

3.215 İtibar

8 adet Kılavuz yazıldı

Takım

Cal Poly, Team 17-20, Forte Winter 2013 Cal Poly, Team 17-20, Forte Winter 2013 üyesi

CPSU-FORTE-W13S17G20

5 Üyeler

18 adet Kılavuz yazıldı

Bir Yorum

This is either incomplete or mistitled - it is a currently a back plate replacement guide.

At the conclusion of this how-to/walkthrough, most of the GamePad's hardware is still attached to the front plate, one half of the outer case.

Elijah - Yanıt

İstatistikleri Görüntüle:

Son 24 Saat: 1

Son 7 Gün: 17

Son 30 Gün: 91

Her zaman: 9,348