Eşyalarını Tamir Et Topluluk Mağaza

Wire Stripping

Giriş

Wire needs to be exposed from its insulation in order before it can be soldered to another wire. Wire stripping exposes the wire so you are able to make good connections.

Neye ihtiyacın var

  1. Wire Stripping, Wire Stripping: adım 1, 1 resimden 1.

    • Match your gauge of wire to the gauge on a wire stripper.

    • Some wire strippers will have two gauge sizes for the same hole, one for solid wire and one for stranded. Make sure you use the right one for the wire you are stripping!

    Düzenle

  3. Wire Stripping: adım 2, 1 resimden 1.

    • Place the wire stripper about a 1/4” from the end of the wire and squeeze down.

    • You can strip more than 1/4" at a time, but the effort becomes harder. About 1/2-5/8" (13-16 mm) is the most you should probably attempt.

    Düzenle

  4. Wire Stripping: adım 3, 1 resimden 1.

    • While squeezing, pull the stripper toward the end of the wire. This should expose some of the wire by removing its insulation.

    Düzenle
Sonuç

After your wire has been stripped, the exposed wire is ready to be soldered and reconnected to other parts of the microphone.

18 farklı kişi bu kılavuzu tamamladı.

Yazar

9 tane daha katılımcı ile

nat coll

Üyelik tarihi: 09/27/12

811 İtibar

14 adet Kılavuz yazıldı

Rozetler: 13

+10 tane daha rozet

Ekip

Cal Poly, Team 7-53, Forte Fall 2012 Cal Poly, Team 7-53, Forte Fall 2012 üyesi

CPSU-FORTE-F12S7G53

5 Üyeler

33 adet Kılavuz yazıldı

0Kılavuz Yorumları

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 23

Son 7 gün: 126

Son 30 gün: 495

Her zaman: 9,881