Eşyalarını Tamir Et Topluluk Mağaza

Wolf Gourmet WGBL100S Control Board Replacement

Giriş

If your blender does not operate, try opening it as per this guide and checking the wires on the control board. If that yields no results, consider replacing the board if possible.

Neye ihtiyacın var

  1. Wolf Gourmet WGBL100S Control Board Replacement, Control Board: adım 1, 2 resimden 1. Wolf Gourmet WGBL100S Control Board Replacement, Control Board: adım 1, 2 resimden 2.

    • Flip the base of the blender upside-down.

    • Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.

    Düzenle

  2. Wolf Gourmet WGBL100S Control Board Replacement: adım 2, 2 resimden 1. Wolf Gourmet WGBL100S Control Board Replacement: adım 2, 2 resimden 2.

    • Using the metal spudger, pry off one half of each rubber foot.

    • Note that one side of the foot is glued down; pry off the other side.

    Düzenle

  3. Wolf Gourmet WGBL100S Control Board Replacement: adım 3, 1 resimden 1.

    • Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.

    • Pull the base off of the blender.

    Düzenle

  5. Wolf Gourmet WGBL100S Control Board Replacement: adım 4, 2 resimden 1. Wolf Gourmet WGBL100S Control Board Replacement: adım 4, 2 resimden 2.

    • Pull off the plastic housing.

    Düzenle

  6. Wolf Gourmet WGBL100S Control Board Replacement: adım 5, 2 resimden 1. Wolf Gourmet WGBL100S Control Board Replacement: adım 5, 2 resimden 2.

    • Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.

    Düzenle

  7. Wolf Gourmet WGBL100S Control Board Replacement: adım 6, 2 resimden 1. Wolf Gourmet WGBL100S Control Board Replacement: adım 6, 2 resimden 2.

    • Using pliers, pull off all the connectors on the top.

    Düzenle

  8. Wolf Gourmet WGBL100S Control Board Replacement: adım 7, 1 resimden 1.

    • Pull or pry off the last connector block, then remove the control board.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

5 tane daha katılımcı ile

Cole Gillespie

Üyelik tarihi: 04/19/18

476 İtibar

2 adet Kılavuz yazıldı

Rozetler: 9

+6 tane daha rozet

Ekip

Cal Poly, Team S25-G16, Maness Spring 2018 Cal Poly, Team S25-G16, Maness Spring 2018 üyesi

CPSU-MANESS-S18S25G16

4 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 12

Her zaman: 318