X-Treme Tablet Generation 2 Motherboard Replacement

Yazan: Dalton Croslow (ve 4 başka katılımcı)

Yorumlar: 0
Favoriler: 0

X-Treme Tablet Generation 2 Motherboard Replacement

Zorluk

Orta

Adımlar

Gerekli Süre

30 - 40 dakika

Giriş

Before proceeding, make sure you have all the necessary parts and tools for this replacement guide. This is over the replacement of the motherboard for XTreme Tablet Generation 2. If you feel the need, use safety glasses and gloves when applicable.

Aletler

Bu aletleri satın al

Parçalar

ARM Cortex A8 Processor

Başka bir siteden satılık

Satın Al

Adım 1 Motherboard

Remove the cover from the back of the tablet. Using the pick tool, pry the cover the case. Do this by starting in the upper corner, working around the edges until the cover unclips from the case.

Remove the cover from the back of the tablet. Using the pick tool, pry the cover the case. Do this by starting in the upper corner, working around the edges until the cover unclips from the case.

Düzenle

Adım 2

Find and detach all of the connections to the motherboard. Remove the connections while leaving the components in place from the battery, camera, ground wire, plastic connections at the charging port, and the 512MB DDR3 SDRAM.

Find and detach all of the connections to the motherboard. Remove the connections while leaving the components in place from the battery, camera, ground wire, plastic connections at the charging port, and the 512MB DDR3 SDRAM.
Remove the connections using a soldering iron and desolder pump to remove the current soldered connections.

Düzenle

Adım 3

Replacing the defective motherboard with a functional motherboard: Reattach the connections at the battery, camera, ground wire, plastic connections at the charging port, and the 512MB DDR3 SDRAM.

Reattach the connections by soldering them back onto the motherboard using a soldering iron.

Replacing the defective motherboard with a functional motherboard: Reattach the connections at the battery, camera, ground wire, plastic connections at the charging port, and the 512MB DDR3 SDRAM.
Reattach the connections by soldering them back onto the motherboard using a soldering iron.