Giriş

Learn to remove and replace the main circuit board in your keyboard with this guide. The process is moderately involved and requires the removal of many screws and light force for some parts.

  1. Turn the keyboard over so that the keys are facing the ground.
    • Turn the keyboard over so that the keys are facing the ground.

    Yorum Ekle

  2. Pop the tabs on the battery casing and remove it from the back plate.
    • Pop the tabs on the battery casing and remove it from the back plate.

    Yorum Ekle

    • Locate the six batteries and remove them from the battery cavity.

    what type of batteries? and how much ?

    thanks godbless

    colladonelson - Yanıt

    • Remove the six 10mm screws at the top of the backplate.

    Yorum Ekle

    • Remove the seven 12mm screws in the middle of the back plate.

    Yorum Ekle

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the eight 10mm screws from the side and the bottom of the back plate.

    Yorum Ekle

    • As the face plate is no longer connected to the body of the keyboard, be careful to not drop the body when performing this step.

    • Flip over the keyboard

    Yorum Ekle

    • Lifting from the front and the back of the face plate equally, pull the face plate up and then back, away from the keyboard.

      • Be careful when removing the face plate. There are wires attached.

    Yorum Ekle

    • Locate the main circuit board - it should be toward the middle of the detached face plate.

    Yorum Ekle

    • Use a plastic opening tool or spudger to carefully pry up the beige ribbon connectors and remove the wires from them.

      • Be sure to use a tool that is ESD safe!

      • Use a slightly upward force as parallel to the ground as possible.

      • Be sure to make a mental note or jot down the locations of the specific ribbon cables. Some are in close proximity to each other and it can be easy to forget which ribbon goes where.

    • Be sure to unplug the smaller ribbon that connects to a different circuit board.

    • Take care not to use too much force. The connectors are fragile, the ribbon wires are easily bent, and too much force may damage the circuit board if you happen to miss.

    Yorum Ekle

    • Move the ribbons out of the way and remove the eight 10mms crews in the middle that hold the circuit board down.

    • Remove the two 12mm screws in the corner of the circuit board.

    Yorum Ekle

    • Remove this wire carefully by hand.

    Yorum Ekle

    • Completely remove the circuit board from the face plate.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

7 başka kişi bu kılavuzu tamamladı.

Lonnie Bissmeyer

Üyelik tarihi: 16-09-2012

300 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 2-62, Propen Fall 2012 Cal Poly, Team 2-62, Propen Fall 2012 üyesi

CPSU-PROPEN-F12S2G62

2 Üyeler

6 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 4

Son 7 Gün: 16

Son 30 Gün: 79

Her zaman: 5,438