Ana içeriğe geç

Retina MacBook 2015 Battery Replacement Giriş değişiklikleri

Düzenleyen: Jeff Suovanen

Düzenleme onaylandı tarafından Jeff Suovanen

Silindi
Eklendi
Değiştirilmemiş
Cihaz
[ ]Retina MacBook 2015
Type
[ ]replacement
Thing
[ ]Battery
Title
[ ]Retina MacBook 2015 Battery Replacement
Introduction
Use this guide to remove and replace the glued-in battery from your 12-inch MacBook with Retina Display. This is best done with the help of an iFixit battery replacement kit; the liquid adhesive remover in your kit will dissolve the adhesive securing the battery, allowing you to remove it with ease. [ … ] '''iFixit adhesive remover is flammable.''' Perform this procedure in a well-ventilated area. Do not smoke or work near an open flame during this procedure. [ … ] '''For your safety, drain your MacBook Pro's battery before you begin this procedure.''' A charged lithium-ion battery can create a dangerous and uncontrollable fire if accidentally punctured. [ … ] The MacBook's battery contacts are located under the logic board, and this guide recommends removing the logic board completely for battery replacement. While it's possible to remove the logic board screws and simply tip the board up slightly to remove the battery, it's very difficult to install a new battery correctly with the logic board still in place. [ … ] '''Note''': The solvent used to dissolve the battery adhesive can damage and/or discolor certain plastics. Take care where you apply the solvent. [ … ] '''To avoid logic board damage''', when your MacBook repair is complete ''but before powering it on'', [https://www.ifixit.com/Guide/Applying+Low+Voltage+After+Every+Repair+%28Retina+MacBook+2015+Only%29/107711|connect it to low-voltage power] using a 5-Watt iPhone charger and a USB-C to USB-A cable. These accessories are not included with your MacBook, so make sure you have them ready before you begin.
Time Required Min
2 saat
Time Required Max
3 saat
Imageid
Önce
Sonra
Difficulty
Difficult
Conclusion
[ ]To reassemble your device, follow these instructions in reverse order. To avoid logic board damage, when your MacBook repair is complete ''but before powering it on'', [https://www.ifixit.com/Guide/Applying+Low+Voltage+After+Every+Repair+%28Retina+MacBook+2015+Only%29/107711|connect it to low-voltage power] using a 5-Watt iPhone charger and a USB-C to USB-A cable.
Author
Public
Hayır
Summary
[ ]Replace the glued-in battery in your 12" MacBook with Retina Display (2015).

Kılavuz Ön Koşulları

Aletler

  • P5 Pentalobe Screwdriver Retina MacBook Pro and Air x1 added.
  • Spudger x1 added.
  • Tweezers x1 added.
  • iPad Battery Isolation Pick x1 added.
  • T5 Torx Screwdriver x1 added.
  • Tri-point Y00 Screwdriver (for MacBook) x1 added.

İşaretler

  • In Progress added.

Adımlar

Step #: 1
Önce
Sonra
Step #: 2
Önce
Sonra
Step #: 3
Önce
Sonra
Step #: 4
Önce
Sonra
Step #: 5
Önce
Sonra
Step #: 6
Önce
Sonra
Step #: 7
Önce
Sonra
Step #: 8
Önce
Sonra
Step #: 9
Önce
Sonra
Step #: 10
Önce
Sonra
Step #: 11
Önce
Sonra
Step #: 12
Önce
Sonra
Step #: 13
Önce
Sonra
Step #: 14
Önce
Sonra
Step #: 15
Önce
Sonra
Step #: 16
Önce
Sonra