Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

How To Repair Jammed CanoScan LIDE 90 Scanner Girişe yapılan Değişiklikler

Düzenleyen: dan

Onay bekleniyor

Silindi
Eklendi
Değiştirilmemiş
Cihaz
[ ]CanoScan LIDE 90
Type
[ ]repair
Thing
[ ]Casing Spine
Title
[ ]Repairing CanoScan LIDE 90 Casing Spine
Introduction
If your scanner gets jammed half way through then it could be that the casing is bent [ … ] There is a metal 'spine' that runs the length of the base inside the casing. This pushes the scanner head up and into the glass causing the motor to 'lockup' and creating a horrible noise. [ … ] If you open up the scanner and bend it flat again it solves the problem. [ … ] You can tell if it needs this by turning the scanner upside-down and placing a straight object (metal ruler?) along the length of the scanner back. If you can see bowing (dipping or a curve down) towards the centre of the back casing, the rail inside is probably bent.
Time Required Min
Tahmin yok
Time Required Max
Tahmin yok
Difficulty
Moderate
Conclusion
[ ]To reassemble your device, follow these instructions in reverse order.
Author
dan
Public
Hayır
Summary
[ ]Does your scanner lock-up and jam half way through scanning with a horrible grinding noise?

İşaretler

  • In Progress added.
  • Member-Contributed Guide added.

Adımlar

Step #: 1
Önce
Sonra
Step #: 2
Önce
Sonra
Step #: 3
Önce
Sonra
Step #: 4
Önce
Sonra
Step #: 5
Önce
Sonra
Step #: 6
Önce
Sonra
Step #: 7
Önce
Sonra