Ana içeriğe geç

Eşyalarını Tamir Et

Onarma Hakkı

Parçalar ve Aletler

Changes to Disassembling Xelio P1001A-BK Removing the Back Cover Introduction

Düzenleyen: Michael Case

Düzenleme onaylandı tarafından Michael Case

Silindi
Eklendi
Değiştirilmemiş
Introduction
Removing the back cover of this table is fairly simple and straight forward. It requires removing two small screws located on the end of the tablet where the power, micro-USB, SD card and headphone ports are located. Once the screws are removed a thin blade flat head screw driver is all that is needed to pry apart the two shell halves of the tablet. [ … ] The table tablet speakers have magnets on their backs which should make them stick to the metal shell protecting the back of the screen. However, if the speakers stay attached to the back shell half, gently pry them out of the sockets before completely separating the shell halves. [ ] One other caution is to use a magnetized screw driver when removing the screws from the shell as the only measure about3 mm long by 2 mm across their head. They would be real easy to lose so take care to keep tight control of them. Put them in a plastic bag to keep them safe while working on the tablet. [ ] Disassembly should only take about five minutes, but take time and do not force disengaging the securing tabs. Once you open the back of the tablet you will see the mother board, battery, screen back, Wi-Fi antenna and speakers. halves.
Removing the back cover of this table is fairly simple and straight forward. It requires removing two small screws located on the end of the tablet where the power, micro-USB, SD card and headphone ports are located. Once the screws are removed a thin blade flat head screw driver is all that is needed to pry apart the two shell halves of the tablet. [ … ] The table tablet speakers have magnets on their backs which should make them stick to the metal shell protecting the back of the screen. However, if the speakers stay attached to the back shell half, gently pry them out of the sockets before completely separating the shell halves. [ ] One other caution is to use a magnetized screw driver when removing the screws from the shell as the only measure about3 mm long by 2 mm across their head. They would be real easy to lose so take care to keep tight control of them. Put them in a plastic bag to keep them safe while working on the tablet. [ ] Disassembly should only take about five minutes, but take time and do not force disengaging the securing tabs. Once you open the back of the tablet you will see the mother board, battery, screen back, Wi-Fi antenna and speakers. halves.